Transcript Remote Testing Guidelines

Accuplacer Remote Testing
Proctor Instructions
Regis College
235 Wellesley Street
Weston, MA 02493
Step 1: Verification
• Go to
www.accuplacer.org
• Click “Verify System”,
which is highlighted in
red and is located in the
bottom right portion of
the screen
• Mozilla FireFox is
recommended
Step 1: Verification (Continued)
• Once you click “Verify
System”, this should be the
screen that you see
• At the top you should see,
“The following information
shows if this workstation
meets the minimum system
requirements necessary to
run ACCUPLACER…”
• If the screen is accurate,
please return to
www.accuplacer.org
Step 2: Log On
• On www.accuplacer.org,
please use the log on
information which was
provided in the email
• Once the information
accurately filled in, please
press the blue button labeled
“Login”
• Please note that the log on
information from the email
will expire 72 hours after the
original testing time has
ended. If your log on
information has expired,
please contact
[email protected]
Step 3: Advertisement
• Once you log on, an
announcement, such as
the one to the right, will
appear. Please click
“Close”, highlighted in
red in the bottom right
corner
Step 4: Test Set-Up
• On the left-hand side of
the screen will be a
menu
• Click on “Administer
Test”
• Then click on
“Administer New Test
Session”
Step 5: Administer the Test
• Please click the drop
down menu under
“Administer New Test
Session”
• Select “*REGIS.pro”
• Click “Administer Test”
• Please note that you need
to have the pop-up
blocker disabled or you
will not be able to
continue
Step 6: Begin Testing
• Once the pop-up appears,
please press the fullscreen button in the top
right corner
• Scroll to the bottom of
the page
• Press “Accept” to the
agreement to begin the
Accuplacer Test
• The “Student ID” needed
on the next page is
located in the email
Step 7: Completion
• Once Accuplacer has
been completed, please
close all Accuplacer
screens