Transcript DCN MPCC Product overview / Technical information/ Multi PC's

Security Systems BU Communication Systems
Multi PC’s

High Performance PC’s

Microsoft Windows® NT 4.0, 2000 or XP

Direct connection with CCU allows PC
to communicate with DCN system

08.12.2004
DCN MPCC PO MPC
Network set-up allows more PC’s to
communicate with DCN system
DCN
ST/SEU-CO 1
Security Systems BU Communication Systems
PC requirements with software platform
Windows® NT 4.0, 2000, XP















08.12.2004
Pentium II processor or higher.
96 Mbytes of Random Access Memory (RAM) or more (at least 64 Mbytes)
Hard Disk 1 Gbytes or more with a data access time of <10 ms.
Cache memory 256 Kbytes or more.
Floppy disc drive: 3.5” 1.44 MB.
Video card supporting at least VGA and SVGA resolution high or true colours (256
minimal) Video memory at least 1 Mbytes.
The DCN_Network card LBB 3510/00 NOT supported!
Free RS-232 port for direct connection to CCU.
Free PCI or ISA-bus expansion slot or UTP connector for Network set-up.
2 x Serial ports (4 Serial ports recommended if a Chip-card encoder is used)
1 x Parallel ports for connection to optional equipment.
Local Bus mouse port for Serial 2- button mouse.
Keyboard.
Optional equipment: Printer (parallel and / or serial) Chip Card encoder
IMPORTANT:
The operator has no connection to the PC for headphone or intercom handset.
Additional DCN hardware is required for the operator if these functions are
required. DCN table- top or flush mounted hardware depending on the
requirements can be used.
DCN MPCC PO MPC
DCN
ST/SEU-CO 2
Security Systems BU Communication Systems
Extra Requirement for Windows XP

08.12.2004
XP Service Pack 2 has to be installed on the PC’s!!
DCN MPCC PO MPC
DCN
ST/SEU-CO 3
Security Systems BU Communication Systems
Multi PC’s
End of section
 Robert Bosch GmbH
All rights are reserved. Reproduction or passing on to
third parties in whole or in parts is prohibited without the
written consent of the copyright owner.
08.12.2004
DCN MPCC PO MPC
DCN
ST/SEU-CO 4