DCN SPCC PO Central Control Equipment
Download
Report
Transcript DCN SPCC PO Central Control Equipment
Security Systems BU Communication Systems
Central Control Unit (Com - ports)
LBB3500/15
2 x 9-pin Sub-D connector RS 232 for:
Facilities
factory testing (diagnostics)
direct PC control
camera control
remote control (Open interface)
applications for:
- Mimic panel (Microphone control)
- Voting panel
- Attendance registration
- Intercom
- Message Distribution
08.12.2004
DCN SPCC PO CCE
I&O Manual
ST/SEU-CO 1
Security Systems BU Communication Systems
Central Control Unit (Com - ports)
LBB3500/15
Open interface applications for remote controller
The DCN system provides a facility for controlling microphones,
microphone management modes, attendance registration and voting from a
remote controller.
The remote controller can be custom built for a given application to control
microphone activity - for example a push- button panel, with on/ off pushbuttons and indicator. LEDs assigned to each microphone position can be
used to control delegates microphones from a remote position.
The communication protocol is message based binary interface (i. e remote
functions and update information).
Note: Before third parties can use the remote interface, the interface
must be enabled on the CCU by installing the LBB3587 key-disk.
- Only possible by using the LBB 3500/15 or /35
08.12.2004
DCN SPCC PO CCE
ST/SEU-CO 2
Security Systems BU Communication Systems
CCU Trunk Communication Board (TCB-4)
Key to symbols :
1 Jumper X14 (See Chapter 4.5.3 (Table 4.4))
2 S14 DIP- switches 1 - 8 (See Chapter 4.6 )
3 S10 Push- button switch to reset the Central
Control Unit during servicing.
4 Three LEDs (left to right) green/ yellow/ red.
Normally the green/ yellow LEDs flash in
sequence, indicating the software is running.
Red LED illuminates during system reset.
5 S9 DIP- switches 1 - 8 (See Chapter 4.5.2
(Table 4.3))
6 Yellow LED indicates Digital Signal Processing
(DSP) software is running.
7 Connector for multi- trunk board (used only in
the multi- CCU)
8 Sockets for inserting flash EPROM (even)
9 Sockets for inserting flash EPROM (odd)
08.12.2004
DCN SPCC PO CCE
ST/SEU-CO 3
Security Systems BU Communication Systems
CCU Trunk Communication Board (TCB-4)
Key to symbols :
10 SRAM back- up battery 3.6 V (life- time 5
years min.)
11 Jumper X13 (See Chapter 4.5.3 (Tables 4.4))
12 Fuse 3.15 amp (delayed)
13 Connector for multi- trunk board (used only in
the multi- CCU)
14 Serial RS232 Port 1
15 Serial RS232 Port 2
08.12.2004
DCN SPCC PO CCE
ST/SEU-CO 4
Security Systems BU Communication Systems
Central Control Unit (Com - ports)
LBB3500/15
LBB 3500/ 15 and LBB 3500/ 35 (TCB 4)
Port 1 : DCN Control PC
Port 2 : Camera Control
In a single (stand- alone) CCU system two
serial COM- ports (Port 1 and Port 2) are
available. Both ports can be individually
configured.
NOTE: It is possible to select ‘Full’ protocol
on both Port 1 and Port 2. However this is
NOT recommended due to processing power
and memory limitations.
Default settings are;
•8 data bits
•No parity check
•1 Stop bit
08.12.2004
DCN SPCC PO CCE
ST/SEU-CO 5
Security Systems BU Communication Systems
TCB-4 DIP Switch Settings
(default)
08.12.2004
DCN SPCC PO CCE
ST/SEU-CO 6
Security Systems BU Communication Systems
Central Control Unit (Audio I/O)
LBB3500/15
1. Asymmetrical Recorder In- & Outputs
2. 2 Asymmetrical line input connectors
2
3. Symmetrical or 2 Asymmetrical line
outputs
1
3
08.12.2004
DCN SPCC PO CCE
ST/SEU-CO 7
Security Systems BU Communication Systems
Central Control Unit (Audio I/O)
LBB3500/15
1. Tape/cassette recorder input and output (Cinch-type)
Tape In Asym.
nom. -33 dBV
max. -3 dBV
Tape Out Asym.
nom. -33 dBV
max. -3 dBV
2. 2 Asymmetrical line input connectors (Cinch-type)
Line In Asym.
nom. -18 dBV
max. +12 dBV
3. Symmetrical/Asymmetrical line output connectors (Cinch-type)
08.12.2004
Line Out Sym.
nom. -12 dBV
max. +18 dBV
Line Out Asym
nom. -18 dBV
max. +12 dBV
DCN SPCC PO CCE
ST/SEU-CO 8
Security Systems BU Communication Systems
Central Control Unit (Trunk Outlets)
LBB3500/15
1. Red LED overload indicators
2. Trunk outlet used for loop-through of the
trunk-line-cable
Trunk
2
1
08.12.2004
DCN SPCC PO CCE
ST/SEU-CO 9
Security Systems BU Communication Systems
Central Control Unit (Trunk Outlets)
LBB3500/15
Trunk outlets
PCF=<60 max.
For loop-through of the DCN trunk-line without
regenerating the digital signal.
Power handling capacity maximum:
-
60 PCF per outlet
- 180 PCF total for the three outlets of the CCU.
08.12.2004
DCN SPCC PO CCE
ST/SEU-CO 10
Security Systems BU Communication Systems
Extension Power Supply
LBB4106/x0
1. Mains socket with built-in fuse
115V-T4A/230V-T2A
Mains voltage
Mains fuse
220, 230, 240 V AC.
T- 4A (slow blow)
Nominal
Power Consumption
350 W
105, 115 V, 125 V AC. T- 5A (slow blow)
Warning:
All units must be powered via an earthed mains outlet.
08.12.2004
DCN SPCC PO CCE
I&O Manual
ST/SEU-CO 11
Security Systems BU Communication Systems
Central Control Equipment
End of section
Robert Bosch GmbH
All rights are reserved. Reproduction or passing on to
third parties in whole or in parts is prohibited without the
written consent of the copyright owner.
08.12.2004
DCN SPCC PO CCE
ST/SEU-CO 12