Transcript living with the lab pump fabrication – day 1 group B will make their pump group A will draw their pump.

living with the lab
pump fabrication – day 1
group B will make their pump
group A will draw their pump
living with the lab
faceplate
impeller
(your own design)
group A: SolidWorks modeling
•
•
•
•
measure & draw a screw
measure & draw a barbed fitting
(don’t worry about screw threads & intricate details)
measure & draw the motor
complete your assembly in Solidworks
pump body
other parts &
pump assembly
2
living with the lab
group A: robot challenge
•
•
•
work on the robot challenge after finishing the SolidWorks assembly (if time permits)
solder photoresistors or complete other robot work
work on programming (move a mat to your table)
3
living with the lab
group B: make your pump
•
•
•
•
don’t start until you receive safety training from your instructor
turn in signed safety quizzes after training
follow directions on the PowerPoint presentation
if you are unsure of something, then ask for help
4