Transcript مار- فكس MAR-FIX

DECORATIVE SINGLE COAT PLASTER FOR MARBLE CHIPS
CLADDING SYSTEM
( PEBBLEDASH )
Water proof colored cement based mortar with good
adhesion, for the protection and decoration of façades
Water repellent while at the same time allowing the structure
to breathe
Excellent dirt pick-up resistance and is extremely stable
against ultra violet light even in severe climatic conditions
Applied manually and available in a range of 12 colours
PROPERTIES
Formulated using a mixture of precisely graded fillers,
cement, perlite, silica sand, pigments and additives
Finished by spraying a layer of marble chips over the surface
and working them into the surface with a steel trowel.
ADVANTAGES
:
1. LONG LIFE
2. DIRT PICK-UP RESISTANCE
3. EXCELLENT UV STABILITY
4. WATER REPELLENT
5. PLASTERING / FINISHING
IN ONE OPERATION
6. GOOD MECHANICAL STRENGTH
AREA OF USE:
Exterior wall for direct application on clay brick, concrete
block, AAC block, precast/in-situ concrete and stone.
PREPARATION OF SURFACE:
1. Ensure all dust, dirt and foreign matter are brushed and
scraped away.
2. ensure surface is solid, free from salts, oil, grease and
ridges.
3. Protect all adjacent surfaces not to be coated.
4. Apply a coat of penetrating primer to absorbent surfaces
such as AAC blocks.
5. A key coat is required on very smooth surfaces such as
precast or in-situ concrete (1pt Mar-Fix, 0.4 pts. water,
0.08 pts. bond)
MIXING:
1. Mix 20 kg of Mar-Fix
with 5–6 litres of clean water for 3 minutes.
2. Ensure that mixing time and ratio of powder/ water are
constant to ensure colour consistency.
3. Allow the mortar to stand for 5 minutes, remix and use.
Prepared material should be used within one hours.
APPLICATION AND CLEANING OF TOOLS:
1. Saturate the substrate with water to reduce suction of
water from the product the day before application and again
one hour before application.
2. Spread the mortar over the substrate in a 4-6 mm layer.
3. Trowel to a smooth level surface.
4. After a period of approx. 10 minutes spray the marble chips
over the mortar.
5. Tamp the surface with a trowel to embed the chips into
the mortar.
6. Clean equipment with clean water immediately after use.
PRECAUTIONS:
1. Do not apply below 8 Degree Celsius as there is risk of
efflorescence.
2. Do not apply on horizontal or sloping surfaces.
3. Do not apply on gypsum-based substrates.
4. Do not use at ground level to avoid staining.
5. When applying at high temperatures, ensure that surface is
cured for at least 72 hours after application.
HEALTH & SAFETY
1. Avoid prolonged contact with eyes and skin.
2. Avoid breathing dust. For detailed information refer to the
relevant Material Safety Data Sheet.
PACKAGING
&
STORAGE
1. Packed in a polypropylene sacks of 20 kg net weight on
wooden pallets.
2. Should be stored in a clean, shaded, and dry area as
supplied.
3. Unopened bags can be stored for 6 months.