Transcript Additional Info

GLAST LAT Project
March 08, 2004
ACD Installation, Post LAT CDR
• Response to GLAST LAT CDR RFA Number 13: MGSE Detailed
Dimension Study [for ACD Installation]
– A) Perform detailed dimension study. Crane hook height
appears inadequate for installation of ACD
• See slides 3 and 4
– B) Provide information on the clean room entrances and
clearances that will exist when equipment (including GSE) is
brought in and out.
• Large, Double Door to Class 100K Crane Room is 111” [ 2,819 mm ]
wide by 108” [ 2,743 mm ] high
• Small, Single Door to Class 100K Clean Room is 59” [ 1,499 mm ]
wide by 79” [ 2,007 mm ] high
• The LAT on the Integration Stand, the Low Profile ACD Integration
Stand and the 8’ x 8’ x 6.2’ tall ACD Dolly fits in Rm 104; See slide 5
Page 1
GLAST LAT Project
March 08, 2004
ACD Installation, Post CDR Concept
• SLAC will develop a low profile integration stand
• When ready for ACD mate operations, the LAT will be lifted
from the Rotation / Support Stand and set onto the low profile
stand
• Next slide shows available clearances
• The “available clearances” assume an 8” [ 203 mm ] high
spreader
– Current welded joint analyses indicate that the spreader
needs to be at least 8” high (i.e., Rectangular Structural
Steel Tubing that is also 6” wide and 0.375” thick)
– 13.6” [ 345 mm ] of room to operate crane along Z (vertical)
Page 2
GLAST LAT Project
March 08, 2004
ACD Installation, Low Profile Integration Stand
LAT 4x4 Lift
Spreader (8” [203
mm] Height), 6”
[152 mm]
Clearance
between Spreader
and ACD, Plus
Crane Scale
requires 36”
Crane Lift Block at high point
36.3”
[ 922 mm ]
134”
[ 3,403 mm ]
ACD
6.0”
[ 153 mm ]
97.7”
[ 2,482 mm ]
51.8”
[ 1,316 mm ]
Low Profile ACD
Integration Stand
20.0”
[ 508 mm ]
Page 3
GLAST LAT Project
March 08, 2004
LAT With ACD To / From Rotation Stand
• Crane load block maximum height is 134 inches [ 3,403 mm ] (Hook removed)
• No problem moving LAT to / from integration stand
• 13.6” [ 345 mm ] Operable Height for Crane, with Scale in the loop
Crane Lift Block attaches
directly to Crane Scale that
attaches directly to Lift
Spreader Post
¾” OTS 316 CRES
Turnbuckles Rated
for 5,200 lbs each
Crane Load Block
29.2”
[ 742 mm ]
8,856 lbs
ACD Installed
6.0”
[ 152.4 mm ]
120.4”
[ 3,058 mm ]
53.0”
[ 1,346 mm ]
Page 4
GLAST LAT Project
March 08, 2004
LAT With ACD To / From Rotation Stand
• All Required Hardware for ACD Integration Fits in Room
• ACD Low Profile Integration Stand and its Dolly are within Crane’s
Pick Zone
• ACD on Dolly easily fits through Double Doors ( LAT May require
bagging during door opening events)
ACD Low
Profile
Integration
Stand
ACD on
8’ by 8’
Dolly
Integration
Stand is Placed
to Allow Range
of Motion for
PAPs
Page 5