Transcript Fixing Error E-024

After Receiving this error
code, Follow these steps to
correct the problem…
Click for next slide
You will need a 6inch Philips head screwdriver
Click for next slide
8mm box wrench
Click for next slide
Remove screw from panel close to the control panel
Click for next slide
Then slide the panel to the right…
Click for next slide
Click for next slide
This L.E.D. light should be on, but with this type of
error, it will be off…
Click for next slide
This part is called the “Spanner”, and is what you will
adjust to correct the error.
Click for next slide
A closer look…
Click for next slide
With the 8mm box wrench, adjust the spanner with a slight
turn left or right…
Click for next slide
Until the L.E.D. light is on
Click for next slide
Press the “clear” button and clear the error from the screen.
Click for next slide
Press the “thread cut” button, and your done!