Transcript Cut Cylinder

Department
of
Technological
Education
Graphic Communication
Coatbridge High School
Department of Technological Education
An Elevation and
Plan of a room
layout are shown.
Using the given
sizes and start
position, draw a
Planometric view
of the room layout
(include the back
wall, side wall and
the floor area)
Do not show
hidden detail
(DA10)
Department of Technological Education
Start by drawing
the Plan at the
correct angle.
In this case the
start point is given
at ceiling level so it
is necessary to find
out where the floor
area starts.
Draw the positions
of any furniture
etc. on the floor
area.
Department of Technological Education
Draw the positions
of any walls
required.
Include any doors
and windows on
the walls.
Department of Technological Education
Add any furniture
to the Planometric
view.
Department of Technological Education
Add any furniture
to the Planometric
view.
Department of Technological Education
To finish the
drawing darken
the outlines on the
drawing.
Remember that
the question asks
that hidden edges
are not shown so
some of the lines
will be left as
construction lines.