Transcript Slide 1
Automatic Generation Control for Contract Based Regulation Abstract Our project deals with designing an AGC module that can be used as a teaching tool. This includes using current AGC schemes that must analyze the performance of a control area under different operating conditions. This project necessitates that text and diagrams be integrated into a single module. MATLAB will also be used to identify the process’ ability to regulate within NERC guidelines. Background Below is a block diagram of a typical AGC controller. The system measures the output of the all electrical generators. It also measures the frequency at a satellite location in the system. Finally, it measures the tie flows between interconnected systems. Taking all those measurements, the AGC calculates the amount of power increase needed at each generator to supply the customer load. The power is increased by opening steam valves at the generator and resetting the governor of the turbine. The process runs continuously in real time. http://www.hsb.com/thelocomotive/Story/FullStory/TOOPF1.jpg Proposed Approach Functional requirements Automatic generation control is the center control for power output of the generators, and shall have three major requirements: Frequency: To maintain system frequency at or nearest to 60 Hz Power Flow: To monitor and maintain a balance of input and output power between control areas Power Generation, Operation, & Control Economic Dispatch: To keep each unit’s generation at the least cost. The economic dispatch calculations must carry out once every few minutes Allen J. Wood Technical Approach Introduction This project will require heavy research into automatic generation control. Included in this will be research from the internet, library, and academic writing. The main goal here is to keep the frequency at a nominal value with constraints considerations. The system is receiving input signals from measurements and sending signals to the generators. Steady state differential equation(s) will be derived that describe the relationship between input and output. This equation then can be testing by using SimuLink and MATLAB. Problem Statement The general problem of this project is to produce a PowerLearn Module for training or educational purposes. A useable model for AGC will be produced. It will be integrate text, diagrams, and MATLAB instructions into a complete learning experience for the reader. Intended Users Testing Requirements The system testing approach shall be based off of the data provided to us the author of Power Generation, Operation, & Control. The tests shall include the discovery of system problems. The testing shall involve system response to a change in frequency. How fast the system can bring the frequency back to nominal with the most economic conditions will be analyzed. Testing of the MATLAB code will be done by the team members. o Electrical engineering student o Electrical engineering professors Intended Use Resource Requirement o Electrical engineering student o Electrical engineering professors Personal Effort Assumptions o We will assume a model of a combined cycle generation plant o A system with a maximum of 3 generators o A system comprised of 2 interconnected areas Deliverables o MATLAB Controller o PowerLearn Module Team Members Client Mark Tiemeier Team Leader Electrical Engineer [email protected] Cam Bui Team Member Electrical Engineer [email protected] Chanh Bui Team Member Electrical Engineer [email protected] Peter Rufino Team Member Electrical Engineer [email protected] Department of Electrical and Computer Engineering Iowa State University Advisor Gerald Sheble Professor of Electrical Engineering [email protected] Financial Resources