Transcript PowerPoint - Anviz Global

Anviz Online Training Lesson 12
Menu Guide
Anviz International Technical Support Team
Copyright © 2001-2013 Anviz Global Inc. USA
Illustration for pressing fingerprint
Place finger flatly on the center of scanner window and press a little hard on
scanner for better FP image capture.
You’d better to register the thumb first, then register index finger or middle
finger to increase the precision.
Menu Overview
Enroll FP/PW/CARD
Verify mode
Verify mode content such as SEPT/ANY, RF+PW, PW+FP, RF+FP, and ID+PW.
SEPT/ANY is common used, you may choose different verify mode according to
your need.
SEPT/ANY mode: Access granted is available for FP, or RF, or ID+PW.
Group setting
Group and time zone are access control function.
There are 16 groups and 32 time zones , each group
can set 4 time zones. By default , users are in group 1,
group 0 is normal close and group 1 is normal open.
Admin setup
After adding administrator, it needs the verification of the administrator rights to enter
Menu.
When device is connected to PC , it also needs admin verification before data
communication.
System setting
Device ID should be the same as in the communication software.
Work code is a label to distinguish attendance time of working in different department.
Server mode
Server mode is used in LAN, and device and computer must be in the same network.
When add device in software, select the LAN communication mode and input correct
device IP address to access to PC.
Client mode
Client mode is normally used WAN, you may need to
configure the server IP address(public IP), and map 5010
port in remote network.
System
There are three fingerprint matching precision levels (0, 1, and 2). 0 is lower
precision (Basic) .1 is standard precision(Good). 2 is high precision (Excellent).
Unlock 5: Door is open for 5 seconds when access granted.
Door alert: Device would alarm out if lock isn’t closed in a preset time.
Auto off: LCD backlight setting
System
Auto update: Device will auto update once acquire a better FP template during FP
verification progress.
Log alert: Device will turn on the alarm when the available records are less than the
‘log alert number’. Log alert value ranges from 1 to 5000.
Re-verify interval: Device only save the first record If you make continuous records
with the same finger (time ranges from 1-250 minutes).
USB flash function
Using USB flash to backup data and upload to PC in case of
network and mini-USB communication mode are not available.
New log backup: Download the new records into USB flash driver.
All logs backup: Download all records to USB flash driver.
User backup: Download all users FP templates to USB flash
driver.
User recovery: Recovery user data from USB flash driver.
System info
System info content such as user quantity, FP quantity, log quantity, device SN and
firmware version, which allow you to check how many users and records registered in
device.
Thank you all for watching, if you have any
comments or suggestions, please send e-mail
to [email protected].
For more training information ,go to
http://www.anviz.com/enus/training/ListView/category/4.html
Thank You
Copyright © 2001-2012 Anviz Global Inc. USA
Copyright © 2001-2012 Anviz Global Inc. USA