Transcript MMF Layout, Workflow

MMF Layout, Workflow
Robert Ruland
Magnetic Measurements Facility Layout
Workflow
Summary
October 14, 2004
MMF Review
MMF Layout, Workflow
1
Robert Ruland
[email protected]
Layout
Floor plan divided into three functional areas
Magnetic Measurements (± 0.1º C)
Fiducialization and Assembly (± 1º C)
Storage (± 2.5º C)
Test stand lay-out is driven by requirement to
match the Earth Magnetic Field conditions in
lab to Undulator Hall, i.e. azimuth and gap
orientation need to be identical
October 14, 2004
MMF Review
MMF Layout, Workflow
2
Robert Ruland
[email protected]
Moving and Lifting
Forklift is used to
move undulator
segment in and
out storage racks
as well as on and
off dollies
Dollies are used
to move segments
between rooms
Cranes are used
to load segments
on and off
benches
October 14, 2004
MMF Review
MMF Layout, Workflow
3
Robert Ruland
[email protected]
Tuning / Fiducialization Workflow
All Undulators are tuned to nominal
K, position specific K setting is done
by adjusting relative quad-to-und
alignment
Tuning / Fiducialization Workflow
In storage area, load dolly with undulator
segment
Roll dolly into F&A lab, adjust to
temperature for 3 days
Roll dolly into MM lab, adjust to
temperature for 7 days
Set-up undulator on bench #2, pre-adjust
gap, 2 days
Move onto bench #1, fine-adjust gap,
tune, measure pointed magnet fixture
offset, 3 days
Move onto CMM, finish fiducialization, 1
day
October 14, 2004
MMF Review
MMF Layout, Workflow
4
Robert Ruland
[email protected]
Cradle Assembly Workflow
Pre-assemble Cradle
Move cradle onto assembly bench
Install quad, vacuum chamber, and BPM
Pre-Align and straighten vacuum chamber
Mount undulator
Align Components
Move assembly onto CMM
Set undulator into nominal position
Set roll-away reference
Align Quad wrt undulator
Align BPM wrt Quad
Adjust undulator relative X-position for
local K
October 14, 2004
MMF Review
MMF Layout, Workflow
5
Robert Ruland
[email protected]
END
of
Presentation
October 14, 2004
MMF Review
MMF Layout, Workflow
6
Robert Ruland
[email protected]