Transcript 2N® - NETSTAR, Technical Presentation 2N® - NETSTAR, Technical Presentation • 2N NETSTAR is a communication system that integrates well-proven ISDN technologies with advanced GSM and.

2N® - NETSTAR,
Technical Presentation
2N® - NETSTAR,
Technical Presentation
• 2N NETSTAR is a communication system that
integrates well-proven ISDN technologies with
advanced GSM and VoIP communication networks.
• The implementation capacities of the 2N NETSTAR
system cover a wide range of customer applications
for interconnection of communication channels into
a single converged network, from transition from the
ISDN to multiple providers‘ GSM networks via ISDN
and VoIP interconections to three-way
interconnection of ISDN, GSM and VoIP networks
with a capacity that is sufficient for large
corporations.
• The transition between networks is based on a
powerful dynamic Least Cost Router (LCR), which
automatically chooses the most efficient route to the
required destinations.
2N® - NETSTAR,
Technical Presentation
- Digital PBX for medium-size clients
- Modular concept with up to 424 ports
- Digital and packet call connection => support of IP clients
- Integrated set of company communication applications
- Support of standard telecommunication interfaces and
signalling
- Standard IT interface (XML)
- Web user interfaces
- Set of uniformly designed terminals
- Accessories (surge protection, communicators,
GSM gateways…)
- 8 types of terminals
2N® - NETSTAR,
Technical Presentation
Basic Technical Specification
ISDN PRI - 1 to 13 NT or TE ports
ISDN BRI - 4 to 72 ports
FXO - 4 to 212 input analog lines
FXS - 4 to 424 analog subscriber CLIP lines
UPn - 4 to 72 digital (key) subscriber lines
GSM - 1 to 212 ports
2N® - NETSTAR,
Technical Presentation
Basic Technical Specification 2
- AUDIO-RELAY - 4 to 212 AUX ports + 8 to 224 relays
- VoIP module : 30 simultaneous calls with codec G.711,
10 simultaneous calls with G.729, GSM
and 8 calls with iLBC
- Installation into a 19" rack, or a stand-alone frame
- Extendable by up to 4 units
- 110-230V 50-60Hz /150W mains supply per unit
- Standard UPS back-up
2N® - NETSTAR,
Technical Presentation
System Modularity
- 72 to 424 ports !
- Basic unit + up to 4 extender units
9U
3U
15U
2N® - NETSTAR,
Technical Presentation
Basic Unit
- CPU card
- Switch card
- 3 system slots with data bus
- 9 line card slots
72 ports for an arbitrary, preferably digital
line interface
2N® - NETSTAR,
Technical Presentation
Extender Unit
- Extender controller card (8-bit CPU)
interconnected with Switch card in the
basic unit
- 11 card slots for analog and GSM cards
up to 88 ports
2N® - NETSTAR,
Technical Presentation
Hardware Supported in Units
Basic unit
- up to 72 digital ports
- ASL,ACOL,DSL,BRI,PRI,GSM,
AUDIO-RELAY
Extender units - up to 4 units
- 88 analog ports
- ASL,ACOL,GSM,AUDIO-RELAY
Non-backed-up power supply
- 110V to 230V
- 150W per unit
2N® - NETSTAR,
Technical Presentation
Types of Cards
CPU card
SWITCH card - 1 PRI
PRI card
- 1, 2 and 4 PRI
BRI
- 8 BRI
DSL card
- 8 UPn
COMBO
- 4 BRI and 4 UPn
ASL
- 8 ASL
ACOL/ASL
- 4 ACOL and 4 ASL
AUDIO-RELAY - 4 contacts and 2 audio (stereo)
+ same level 4 contacts and 2 audio
2N® - NETSTAR,
Technical Presentation
CPU Card
- 32-bit control processor
- OS Linux
- Ethernet 100 baseTx, 802.2
for LAN connection [NETSTAR Administrator]
- 1 RS232 [system console]
- support of LAN-to-MMC firmware upgrade
- 1 MMC card slot [MMC v 1.4] for LOG files,
Trace files, accounting files
2N® - NETSTAR,
Technical Presentation
Switch Card
- 512 x 512 digital switch matrix
- Auxiliary control processor
- 4 interconnections with extender units
total of 8Mbps
- 1 PRI interface / PRI licenced
- RJ45 connectors
Version 1 : Switch card with PRI
Version 2 : no interconnection with extender unit
2N® - NETSTAR,
Technical Presentation
PRI Card
- Modularity
1, 2 and 4-port versions
- Up to 3 cards in the basic unit
- TE/NT configuration
HW jumper setup
- Master/slave synchronisation
- Signalling DSS1
- CRC support
- RJ45 connector
2N® - NETSTAR,
Technical Presentation
BRI Card
- Modularity
8 ports - four-wire interface
- Interface configuration
LT-T or LT-S
- Port configuration
P-P or P-MP
- Signalling
DSS1
- Power supply
phantom – 48V
- RJ45 connectors
2N® - NETSTAR,
Technical Presentation
DSL Card
- Two-wire UPn interface
- CORNET proprietary protocol
- CLIP function
- Power supply – 48V
- RJ45 connectors
- 2N StarPoint telephones
2N® - NETSTAR,
Technical Presentation
ASL Card
- Two-wire interface
- CLIP function
with FSK, DTMF signalling
- Line status signalling
polarity reversal
- Power supply - 48V
- RJ45 connectors
- Line load diagnostics
2N® - NETSTAR,
Technical Presentation
4ACOL/4ASL Card
- 4 input analog CO lines
- Automatic fall-back to 4 subscriber
lines (SL) in case of power
failure
- CO line calling line identification
- CLIP function
with FSK, DTMF signalling
- Line status identification
polarity reversal
- RJ45 connectors
2N® - NETSTAR,
Technical Presentation
GSM Card
- Versions: 1, 2 and 4 GSM modules
- Supported networks
[850/900/1800/1900 MHz]
- Voice support
- Transmitted power: 1 - 2W
- Sensitivity: -104 dBm
- SIM card [small 3V]
- Antenna connector
SMA - impedance of 50 Ohm
2N® - NETSTAR,
Technical Presentation
AUDIO-RELAY Card
- 4 contacts and 2 audio (stereo)
- 8 contacts and 4 audio (mono)
- TTL logic
0-5 V logic on the output
- Switching relay
pulse length selection
on/off
2N® - NETSTAR,
Technical Presentation
Terminals
- Analog
pulse and DTMF dialling
- Analog with CLIP reception
FSK and DTMF signalling
- DECT cordless telephones
- ISDN telephones
- Key phones
- IP phones
- SW phones
2N® - NETSTAR,
Technical Presentation
2N StarPoint Digital Terminals
- Two-wire key phones with CORNET protocol
- Telephones with a wide range of user services
- Equipped with an alphanumerical LSD
- Function buttons with LED signalling
- Full-duplex Handsfree with echo suppression
- Extender unit interfaces
Types
2N StarPoint Advance
2N StarPoint Standard
2N StarPoint Economy
2N StarPoint Entry
2N® - NETSTAR,
Technical Presentation
Button Functions:
- Dialling
- MUTE
- FLASH (hold)
- REDIAL
- Intercom
- Handsfree
- Escape
- Telephone directory (list)
- Missed calls
- Outgoing calls
- Received calls
2N® - NETSTAR,
Technical Presentation
2N StarPoint SIP Terminals
- Ethernet 100 Base-T / SIP
- Smart design
- Function buttons with LED signalling
- Extender unit interfaces
- Full-duplex Handsfree with echo
suppression
- Equipped with an alphanumerical LSD
2N® - NETSTAR,
Technical Presentation
2N Star SoftPoint SW Terminals
- software client for a PC
- SIP
- 2N licence
- Codecs G.711,G.729 ,G.723
- Telephone directory (list)
- List of missed, outgoing,
received calls
- Echo suppression
- Call redirection
2N® - NETSTAR,
Technical Presentation
NETSTAR Assistant
- A private www page for every user
- Helps configure service profiles
- Terminal settings
- Call history
- Telephone directories
- CTI phone
2N® - NETSTAR,
Technical Presentation
NETSTAR Administrator
- An offline configuration tool
- LAN-based configuration option, profile saving
- Intuitive configuration
- Firmware upgrade
- Licence update
2N® - NETSTAR,
Technical Presentation
System Features
- Switch matrix for 128 simultaneous calls at least*
- Internal IVR, creation of own tree
- Virtual PBXs
- Mobility Extension
- Different routers for each station
* The switch matrix processes 256 calls at the same time. These 256 channels are
limited to 128 by the connection between the A/D converters and the switch matrix
(128 calls from/to PRI).
2N® - NETSTAR,
Technical Presentation
System Features
Time conditions
- arbitrary number of time conditions
- National/bank holidays
- holiday selection
DISA
- possibility to connect multiple DISAs
to IVR
- arbitrary number
Ringing table
- routing to: station, user and DISA
- time-conditioned router assignment
2N® - NETSTAR,
Technical Presentation
System Features
User dialtones and ringing tones
- any number of tables
Telephone directories (lists)
- private groups, users
- creation of own lists
- list editing in NS Assistant
Groups
- defining groups for ringing and
ringing take-over modes
2N® - NETSTAR,
Technical Presentation
System Features
Trunks
- defining trunks for PSTN and PN seizure
- defining trunks for ringing
- strategy selection (linear, cyclic)
XAPI
- XML commands for CTI application control in
ASSISTANT
- XML commands for MEFISTO hotel system
- XML commands for IP phones
2N® - NETSTAR,
Technical Presentation
System Features
CTI
- application implemented in NS Assistant
IP buffers
- defining IP addresses for accounting line
dowloads
- internal AOC server memory for 25,000
records
- memory for 60 accouting records (20 per filter)
for each station
2N® - NETSTAR,
Technical Presentation
System Services
- Call reception
- Call hold – one active call
- Call alternation – two active calls
- Call transfer
- Return to transferred call
- Return of transferred call
- Ringing take-over
- Call parking
- Call unparking
2N® - NETSTAR,
Technical Presentation
System Services
CLIP
- transfer from ISDN
- transfer from GSM
- transfer within NS
- search of telephone directories for
match
CLIR
- set own
- set common
- cannot be disabled
2N® - NETSTAR,
Technical Presentation
System Services
CPN
- CPN check
- CPN normalizing
Outgoing call
- between any interface
- DTMF and pulse dialling
- dialling restrictions, router settings
2N® - NETSTAR,
Technical Presentation
System Services
Fast dialling
- router settings
BabyCall
- router settings, instantaneous
2N® - NETSTAR,
Technical Presentation
Any questions?
2N® - NETSTAR,
Technical Presentation
Thank you for your attention.