Transcript Common Shape Candle Making Machine Including common shape, pillar shape, spiral shape, taper shape. Commons shape candle machine  The machine is simple in structure and small.

Common Shape Candle Making
Machine
Including common shape, pillar shape, spiral
shape, taper shape.
Commons shape candle
machine
 The machine is simple in
structure and small in size.
The mould are made of
seamless steel pipes. section
steel and steel sheet to
assure precision and easy
operation. The pushrods are
connected with seamless
steel threads and can be
moved up and down to vary
the length of the candle. The
machine is cooled through a
circulating water system.
The machine after be packed
 The various models of candle
expect for specifications on
the catalogue we make other
models of machines
according to the candle sizes
and samples given by the
customers. Besides, we have
more than 280 kind of candle
machines, welcome to order.
We also produce pule
Changeable candle machine
and taillight pressing tally
automatic candle machine.
1.
A brief of the candle making machine
My moulding machines are specially
designed for making candles of
various forms.
2.
Structure and Performance of
common candle making machine
2.1 Structure
The machine is composed of candle
holding dish, water tank, machine
frame, spool box, hand wheel,
spindle, bevel gear, lead screw, nut,
nut shelf, bearing box, cross beam,
push-off tube and candle moulding
tubes, etc.
Candle making machine
 2.2 Performance
 1.2.1 Water tank, candle moulding tube enable the fluid wax to
solidify by means of circulating water in the tube.
 1.2.2
Candle holding dish make usre that the wick is in the
center of the tube and the candle to be properly placed and
clamped.
 1.2.3 Lead heads and push-off tubes are used for the forming of
the candle tip and the push of the candle from the candle
moulding tube.
 1.2.4 The spool box is used for mounting the wick spool.
Operation
4. Operation Process

4.1 Rotate the hand wheel to making cross
beam fall to the lower stopping position.
Place the candle holding-dish in the slot on
the locating plate, pull the locating plate to
the front stopping point. Hang the wick in
the serrate slot of the candle-holding plate.
When the wax liquid half solids, cut off the
wick, remove the candle-holding, dump the
residual wax liquid. When the wax liquid in
the candle moulding tube completely
solidifies, rotate the hand wheel, through
movement of the bevel gear, lead screw,
nut and nut shelf, move the cross rail and
push the candle off tube. Put on the
candle-holding dish to store the candle.
Let the wick enter the serrated hole, rotate
the hand wheel to lower the cross beam to
the lower stopping position.
Candle making machine
5.
Packing
and
transportation
 The
machine
shall
be
covered with a plastic film to
prevent entrance of water. It
shall be enclosed by wooden
box combined with iron nails.
The box shall be reinforced
by iron wires at the two ends
to prevent damages in
transportation. The box shall
not be turned upside-down
and shall avoid clashes.
Do you know Xuguan?
 It is a good thing for me to talk with you about chalk making, if you
have any question or problem, please do not hesitate to contact me.
 Www.xuguan.net
 [email protected]
 [email protected]
 Tel: 86-1300 947 1870