Transcript Slide 1

DIMENSIONING AND TOLERANCING
1
prismatic.sldasm
2
DIFFERENT TYPES OF FIT
Clearance fit
Limits of size defined such that a clearance always
results when mating parts are assembled
Interference fit
Limits of size are so prescribed that interference
always results when mating parts are assembled.
Transition fit
Limits of size are so prescribed that either clearance or an
interference may results when mating parts are assembled
Line fit
Limits of size are so prescribed that surface contact or
clearance may result when mating parts are assembled
3
BASIC HOLE SYSTEM
In the basic hole system the minimum (lower limit) hole size is taken as the basic size.
Stock hole is made “first” and then shaft is made to particular type of fit (to suit the hole).
4
BASIC SHAFT SYSTEM
In the basic shaft system the maximum (upper limit) shaft size is taken as the basic size.
Stock shaft is created “first” and hole is made to particular type of fit (to suit the shaft).
5
IDENTIFY FIT SYSTEM
Basic shaft or basic hole?
In the basic hole system the minimum (lower limit) hole size is taken as the basic size.
Stock hole is made “first” and then shaft is made to particular type of fit (to suit the hole).
In the basic shaft system the maximum (upper limit) shaft size is taken as the basic size.
Stock shaft is created “first” and hole is made to particular type of fit (to suit the shaft).
6
IDENTIFY FIT SYSTEM
“Shaft”
“Hole”
-
=
=
What type of fit is this?
7
IDENTIFY FIT SYSTEM
8
IDENTIFY FIT SYSTEM
Basic hole
Basic shaft
More commonly used
Less commonly used
9
IDENTIFY FIT SYSTEM
Shown are limit tolerances
10
Surface roughness for different manufacturing methods
http://mdmetric.com/pdf/surfruff.pdf
11
12
Φ
Basic hole fits
13
Φ
Basic shaft fits
14
Description of preferred fits
15
ANSI PREFERRED HOLE BASIS METRIC CLEARANCE FITS
Pages 312, 313, 314, 315
ANSI PREFERRED SHAFT BASIS METRIC CLEARANCE FITS
Pages 316, 317, 318, 319
Engineering Design Graphics
James Leake
Jacob Borgerson
16
Nominal
diameter 25mm
Btw. what is wrong
with this assembly?
cylindrical_metric.sldasm
17
Loose running fit for nominal diameter 25mm preferred hole basic
18
Free running fit for nominal diameter 25mm preferred hole basic
19
Close running fit for nominal diameter 25mm preferred hole basic
20
Sliding fit for nominal diameter 25mm preferred hole basic
21
Locational transition fit for nominal diameter 25mm preferred hole basic
22
Locational transition fit for nominal diameter 25mm preferred hole basic
23
Locational interference fit for nominal diameter 25mm preferred hole basic
24
Medium drive fit for nominal diameter 25mm preferred hole basic
25
Force fit for nominal diameter 25mm preferred hole basic
26
Hole is always the same: H7
We obtained the desired fit by changing shaft tolerance
27