Transcript Apparatus Inspection

Apparatus Inspection
Section 703
Procedures
 The driver/operator should follow a systematic procedure
for inspecting apparatus
 This ensures that all important items are checked every time
the inspection is made.
Items to Check
Batteries
Oil
Tires
Proper
Inflation
Fuel
Coolant
System
Electrical
System
Hydraulic
Fluids
Appliances Tools
Lubrication
Equipment
Foam
Systems
Hoses
Belts
Braking
System
Steering
System
Checklist
 You will be required to perform an apparatus readiness check
on a fire apparatus.
Apparatus Maintenance
 Maintenance – keeping something in a state of usefulness or
readiness.
 Repair – to restore or replace that which has become
inoperable.
Apparatus Maintenance
 Engine
The most important phases of engine maintenance are regular
service inspections.
Apparatus Maintenance
 Daily Maintenance:
Includes checking oil level, radiator coolant level, fuel levels,
tires (proper inflation, wear, cuts), equipment inventory,
checking visible and audible warning signals.
Apparatus Maintenance
 Weekly Maintenance:
Bleeding moisture from air brake tanks, removing equipment
from apparatus and cleaning, and the starting of all portable
engines.
Apparatus Maintenance
 Periodic Maintenance:
Includes lubricating all motor, gear, or hand operated
appliances according to manufacturer’s specification
Apparatus Maintenance
 Batteries
Check voltage, specific gravity & corrosion
Check terminals & cables
 Air Filter
Should be serviced by qualified personnel as required.
In Cab Inspection
 Mirrors & seat are properly adjusted
 All electrical switches are in the off position prior to starting
the apparatus
 Let engine warm up before putting under full load (non
emergency responses)
 Inspect seat belts, cuts & fraying
In Cab Inspection
 Gauges are properly working:
 Speedometer, RPM gauge
 Oil Pressure, Fuel
 Ammeter/Voltmeter
 Air pressure gauges,
 Temperature gauges
 Vacuum & Hydraulic Pressure gauges
In Cab Inspection









Controls are properly working
Electrical Equipment switches
Turn signal switches
High bean headlight switches
Heating & AC switches
Radio Controls
Audible warning devices
Windshield wiper
Defroster controls
In Cab Inspection
Gauges
In Cab Inspections
Electronics & Controls
In Cab Inspections
Electronics & Controls
Pump Inspections
Daily
 Operate the pump drive control & pump engages
 All pump panel gages are functioning
 Drain pump and hose lines completely
 Operate pump controls
 Inspect water & foam tanks
 Check the underside for leaks
 Check Deck guns or turrets for range of motion
 Operate valves
Pump Inspections
Weekly
 Flush the pump with clear water
 Check & clean intake strainers
 Check the pump gear box for proper oil level and traces of
water
 Operate the pump primer with all pump valves closed
Pump Inspections
Weekly
 Operate the changeover valve
 Check packing glands for leaks
 Operate the pump pressure control devices
 Operate the foam proportioning system
Pump Panel Gauges
Pump Panel
Master Intake Gauge
Pump Panel
Master Discharge Gauge
Compound Gauge