Transcript HIPO Safety Learning: Could This Happen in Your Operation

HIPO Safety Learning: Could This Happen in Your Operation?
Forklift carriage lowered trapping spotter between the carriage and an
adjacent slip stand.
Traction #2489971
1
Spotter (IP) reaching to guide the
load collar onto CRT. Head located
between forklift carriage & slips
stand.
2
Spotter (IP) viewing
the position of the
load collar.
If you’d like to know
more, contact Kent Corser,
Wells Program Mgr.
(281) 366-2142
What went wrong?
Actions:
3
• The IP installing the load collar on the
41/2” casing running tool (CRT) was
conducting work under the elevated portion
of the forklift.
• Forklift operator did not stop the job when
the IP began to work under the elevated
portion of the forklift.
• Conducting work in a congested area
resulted in the IP being in an unsafe
position.
• Incorrect use of forklift lifting chain on
single fork.
•Drilling contractor will develop a procedure to safely install the
load ring onto CRT from the ground for approval by Tesco prior
to utilization.
•Drilling contractor should get stingers installed & operational
for lift operations & provide training on use of stinger.
•BP & drilling contractor management to develop a structured
program for pre-tower meetings to ensure an effective CoW for
all tasks.
•Drilling contractor to conduct training to close gaps on: forklift
specs, hand signals, risk assessment & identification.
•Drilling contractor will ensure any changes made will be
implemented on all other rigs operated for BP in Wyoming.