Transcript Autoobd

 AD-1 Auto Scanner
Features
Configuration
Software
Diagnose
FAQ
 Features
1.Universal
2.Wireless
3.Remote diagnosing
Home
 Features
4.Platform: Operates on either XP or Vista operating systems.
5. Interface: USB "plug-and-play" technology and high baud
transceiver for faster data transfer.
6. Report: Results can be saved and printed for later reference.
7. Upgrading: Software can be upgraded anywhere via internet.
8. Hardware: Anti-shock rubber guards for stronger, more
durable usage.
…
Home
 Configuration
AD-1 Multiplexer
Battery Clips
Transceiver
Ignition Lighter Cable
Main Cable
Adaptor
USB Line
Storage Case
Home
 Software Download
AD-1 Client Software
AD-1 USB Driver
Download Page: http://www.autoobd.net/english/download/download.asp
Home
 Software Setup
Install the AD-1 client software.
Home
 Main Interface
If use the software at first time, please click the SETTING button
and set COM port..
Home
 Check COM Port
Check the CP210XUSB COM port from
Device Manager.
And then set the same com port
in the AD-1 software as above.
Home
 Wireless Connection
Wireless communication can reach from 20 to 50 meters.
Home
 Connection with wire
You may operate the device based on any laptop or desktop.
The diagnostic connectors would be different due to the vary vehicle.
Home
 Diagnose
Select the model of the car
you want to diagnose
( JAPAN – TOYOTA )
Home
 Diagnose
Select Connector type [ OBDII-16A ]
Home
 Diagnose
Select the system ( ENGINE )
Home
 Diagnose
DIAGNOSE ITEM:
Diagnostic Trouble Codes Information;
Data Stream List;
Active Test.
Home
 Diagnose
Test result: No fault code
Home
 Diagnose
Data stream list
(Simulation Testing result )
Home
 Diagnose
Read ECU Memory
(Audi/VW Testing result )
Home
 FAQ
What can we do if the system still in wait state?
Home
 FAQ
Click RESET back to initial state.
Home
 FAQ
It is due to the software com port setting failed. Go back to the
software main page, click button “ SETTING”, and then select
the correct com port.
( You may refer to the USB driver installation in this manual).
If still same problem, re-plug the USB line and try it again.
Home