Transcript Fluke thermometer 54II

Fluke thermometer 54II
Press green button to turn the
thermometer on or off. If it does
not turn on replace batteries.
Communication
• Load Fluke software into computer
• Connect the infrared receiver sensor to an
Rs232 port on the computer.
• If the computer does not have a Rs232
then use a quatech DSP-100 G Rs232
interface plug in for the portable computer.
• The usb to Rs232 cable converters will not
work in most cases.
Converter cable Rs232 to usb
• http://www.keenzo.com/showproduct.asp?I
D=3802
• An ATEN converter from usb to Rs232 is
said to work by Fluke but has not been
tried.
Right click on my computer to
check for the com port used by the
jeteye infrared sensor
Click on Hardware and then device
Manager
Check to see that the com ports are
active. A is come 6 B is com 10. the
Fluke software supports com 1-9
• Connect the Jeteye infrared adaptor to the
quatech port.
• Put the adaptor next to the fluke and after
turning on the fluke and collecting some
data, send the data to the Fluke by
pressing the yellow key and the pc/irsend
button.
• The fluke will send an infrared single to the
Jeteye and then the fluke software can be
activated.
• Open the FlukeView Forms program only
after activating the fluke meter and Jeteye
infrared communication sensor. Other wise
you will get a communication error
message from the software.
Get the Data
Export the Data to a excel file with
a cvs extension
Collect Data
• On the Fluke press they yellow button and clear
memory button.
• Press logging button then press logging button
again to stop logging
• Press recall to look at data
• The setup sets the time interval and the type of
thermocouple read. Set the time interval at
selection 1 for 1 sec
• The thermocouple is K type see
• http://en.wikipedia.org/wiki/Thermocouple#K