Transcript Introduction

COMPOSITE MATERIALS
•
•
What are composite materials? Two or more materials bound together
Example from civil engineering: Concrete reinforced with steel bars
Reinforced concrete wall
1
COMPOSITE MATERIALS
•
Fiber reinforced composite materials
Reinforcement: Main load carrying member
Binding material:transfers load to fibers, keeps the fiber together
2
FIBER MATERIALS
3
• A Fiber (reinforcement) may be defined as an elongated stringy man-made material.
• A polymer (matrix) is a large molecule consisting of repeating units connected by
covalent chemical bonds.
• Once the polymer is combined with the fibers, the polymerization process must take
place in order to obtain a solid structural composite material.
• Another critical issue is the fiber-matrix bonding. When the composite material is
loaded, both fibers and matrix must be strongly bonded so that they work as a solid
rigid.
4
FABRIC ARCHITECTURES
Woven
Unidirectional
5
COMPOSITE LAMINATES
6
•
SANDWICH CONSTRUCTION
When loads are applied to any beam, such as wing spar most stress occurs at the
outer surfaces.
• Therefore, SANDWICH structure is commonly used in composite construction
to increase the thickness without significant weight penalty
Core material:
Honeycomb
Balsa wood
Foam etc.
Valid for honeycomb cores
7
Typical SANDWICH structure
Bonding material between layers:
Epoxy resin
Core material:
Honeycomb, wood, foam etc.
Upper and lower layers:
Composite material composed of suitable fiber + matrix combination
Typical fiber materials:
E-Glass: Standard fiber glass; workhorse of composites, moderate strength, good
bonding with epoxy, cheap
Kevlar: Organic fibers, high impact resistance, high strength, difficult to work, poor
bonding with epoxy, moderate prize
Carbon: 93-95% carbon content, very high strength and fatigue resistance, excellent
bonding with epoxy, expensive
8
Typical resin(matrix) materials:
Epoxy: Excellent adhesion to fibers, highest strength, low shrinkage, will bond to
dissimilar or already cured materials
Vinly ester: Moderate strength, more resistant to degradation from water/moisture
Polyester: Low strength , fast curing times, exhibit shrinkage, low weathering resistance,
cheapest (non adequate for advanced composites: poor adhesion to carbon and Kevlar)
9
COMPOSITE MANUFACTURING
10
COMPOSITE MANUFACTURING
11
COMPOSITE MANUFACTURING
INFUSION
12
COMPOSITE MANUFACTURING
INFUSION APPLICATIONS
13
COMPOSITE MANUFACTURING
VACUUM BAGGING
14
COMPOSITE MANUFACTURING
VACUUM BAGGING
15
COMPOSITE MANUFACTURING
VACUUM BAGGING
•Release agent: facilitates the extraction of the part.
•Peel ply: leaves the part surface apt to be bonded or painted.
•Prepreg.
•Release film: prevents the resin to reach the bleeder fabric but not the volatiles.
•Bleeder fabric: takes out the excess of resin in order to get the desired fiber fraction.
•Breather fabric:
makes the
vacuum uniform
along the part.
•Vacuum
bag/seal: seals the
cavity to be
vacuumed.
16