Transcript ppt
ESE370: Circuit-Level Modeling, Design, and Optimization for Digital Systems Day 9: September 27, 2010 MOS Transistor Basics 1 Penn ESE370 Fall2010 -- DeHon Today • MOS Transistor Topology • Threshold • Operating Regions – Resistive – Saturation – Velocity Saturation – Subthreshold 2 Penn ESE370 Fall2010 -- DeHon Last Time 3 Penn ESE370 Fall2010 -- DeHon Refinement 4 Penn ESE370 Fall2010 -- DeHon Body Contact • Fourth terminal • Also effects fields • Usually common across transistors 5 Penn ESE370 Fall2010 -- DeHon No Field • VGS=0, VDS=0 6 Penn ESE370 Fall2010 -- DeHon Apply VGS>0 • Accumulate negative charge – Repel Holes ++++++++ - - - - - - - - - 7 Penn ESE370 Fall2010 -- DeHon Inversion • Surface builds electrons – Inverts to n-type – Draws electrons from n+ source 8 Penn ESE370 Fall2010 -- DeHon Threshold • Voltage where strong inversion occurs N A threshold voltage ln F T – Around 2ϕF ni – Engineer by controlling doping (NA) 9 Penn ESE370 Fall2010 -- DeHon Resistive Region COX • VGS>VT, VDS small OX tOX IDS 2 W VDS nCOX VGS VT VDS L 2 10 Penn ESE370 Fall2010 -- DeHon Resistive Region COX • VGS>VT, VDS small OX tOX • VGS fixed looks like resistor – Current linear in VDS IDS 2 W VDS nCOX VGS VT VDS L 2 11 Penn ESE370 Fall2010 -- DeHon Linear or Resistive Region 12 Penn ESE370 Fall2010 -- DeHon Dimensions • Channel Length (L) • Channel Width (W) • Oxide Thickness (Tox) 13 Penn ESE534 Spring 2010 -- DeHon S Transistor Strength (W/L) COX OX tOX IDS 2 W VDS nCOX VGS VT VDS L 2 14 Penn ESE370 Fall2010 -- DeHon D S D Transistor Strength (W/L) • Shape dependence match Resistance intuition R – Wider = parallel resistors decrease R – Longer = series resistors increase R IDS L 2 W VDS nCOX VGS VT VDS L 2 15 Penn ESE370 Fall2010 -- DeHon A Ldrawn vs. Leffective • Doping not perfectly straight • Spreads under gate • Effective L smaller than draw gate width 16 Penn ESE370 Fall2010 -- DeHon Channel Voltage • Voltage varies along channel • If think of channel as resistor – Serving as a voltage divider between VS and VD 17 Penn ESE370 Fall2010 -- DeHon Channel Field • When voltage gap VG-Vxdrops below VT, drops out of inversion – Occurs when: VGS-VDS< VT – Channel is “pinched off” 18 Penn ESE370 Fall2010 -- DeHon Pinch Off • When voltage drops below VT, drops out of inversion – Occurs when: VGS-VDS< VT • Conclusion: – current cannot increase with VDS once VDS> VGS-VT – current must adjust so that VDS= VGS-VT – If current dropped to zero, then would invert and conduct again… Penn ESE370 Fall2010 -- DeHon 19 Saturation • In saturation, VDS= VGS-VT IDS 2 W VDS nCOX VGS VT VDS L 2 • Becomes: IDS 2 VGS VT W 2 n COX VGS VT L 2 20 Penn ESE370 Fall2010 -- DeHon Saturation • VDS> VGS-VT IDS 2 VGS VT W 2 n COX VGS VT L 2 IDS n COX W 2 VGS VT L 2 21 Penn ESE370 Fall2010 -- DeHon Saturation Region 22 Penn ESE370 Fall2010 -- DeHon Short Channel S • Model assumes carrier velocity increases with field – Increases with voltage • There is a limit to how fast carriers can move – Limited by scattering to 105m/s • Encounter when channel short – Field = VDS/L – Modern processes, L is short enough Penn ESE370 Fall2010 -- DeHon 23 D Velocity Saturation • Once velocity saturates: IDS VDSAT satCOX W VGS VT 2 VDSAT L sat n 24 Penn ESE370 Fall2010 -- DeHon Velocity Saturation 25 Penn ESE370 Fall2010 -- DeHon Below Threshold • Transition from insulating to conducting is non-linear, but not abrupt • Current does flow – But exponentially dependent on VGS 26 Penn ESE370 Fall2010 -- DeHon Subthreshold IDS W IS e L VGS nkT / q VDS kT / q 1 e 1 VDS 27 Penn ESE370 Fall2010 -- DeHon Subthreshold S • W/L dependence follow from resistor behavior (parallel, series) – Not shown explicitly in text • λ is a channel width modulation effect IDS W IS e L VGS nkT / q VDS kT / q 1 e 1 VDS 28 Penn ESE370 Fall2010 -- DeHon D Subthreshold Slope • Exponent in VGS determines how steep the turnoff is kT – Every S Volts S n ln 10 – Divide IDS by 10 q IDS W IS e L VGS nkT / q VDS kT / q 1 V 1 e DS 29 Penn ESE370 Fall2010 -- DeHon Subthreshold Slope • Exponent in VGS determines how steep the turnoff is – Every S Volts – Divide IDS by 10 kT S n ln 10 q • n – depends on electrostatics – n=1 S=60mV at Room Temp. (ideal) – n=1.5 S=90mV – Single gate structure showing S=90-110mV 30 Penn ESE370 Fall2010 -- DeHon IDS vs. VGS 31 Penn ESE370 Fall2010 -- DeHon Admin • Text 3.3.2 – highly recommend read • HW3 out • Andre office hours – Some chance Dental appt. overrun tomorrow’s office hours 32 Penn ESE370 Fall2010 -- DeHon Big Idea • 3 Regions of operation for MOSFET – Subthreshold – Resistive – Saturation • Pinch Off • Velocity Saturation – Short channel 33 Penn ESE370 Fall2010 -- DeHon