下載/瀏覽

Download Report

Transcript 下載/瀏覽

Paper review
High Speed 3D Milling by
Dry EDM
Masanori Kunieda1(2), Yukinori Miyoshi1, Tsutomu Takaya1
Nobuhiro Nakajima2, Yu ZhanBo2, Masahiro Yoshida3
1Tokyo University of Agriculture & Technology, Tokyo, Japan
2Sodick Co., Ltd., Yokohama, Japan
3Tokyo Metropolitan College of Aeronautical Engineering, Tokyo, Japan
報告者 : 呂崇成
報 告 日 期﹕96年06月12日
1
大綱

前言

DRY EDM

INTAKE METHOD

結論
2
前言

Dry EDM 就是以氣體代替EDM之加工液。

Dry EDM特性:較低的電極消耗、較薄的白層、放
電時gap較小、無液體腐蝕工件情況。

在高能量密度下,工件與氣體產生熱氧化作用,
其材料移除率可媲美高速銑床。
3
DRY EDM簡介01
Principle of dry EDM
4
DRY EDM簡介02
Mode transition in dry EDM
5
DRY EDM簡介04
火花間隔時間與材料移除率的關係
6
DRY EDM簡介05
Change in size of discharge crater in mode transition
(Gas pressure : 0.1MPa).
7
DRY EDM簡介06
Tool paths for machining 3D surface
8
DRY EDM簡介08
Dry EDM in quasi-explosion mode
9
DRY EDM簡介07
Machining steps used in milling pyramid shaped holes
10
DRY EDM簡介08
Comparison with conventional EDM
11
DRY EDM簡介09
Contours of pyramid shaped holes
12
INTAKE METHOD
Principle of intake method
13
INTAKE METHOD之設備
Apparatus for intake method
14
Pocketing
Pocketing by intake method
15
結果與討論
Comparison of material removal rate
between jetting and intake methods
16
結果與討論
Comparison of tool wear ratio
17
結果與討論
Photos of machined pockets
18
結果與討論
Contours of machined pockets
19
結果與討論
Comparison of thickness of white layer.
20
結論

增加DRY EDM火花能量密度可提高熱氧化
反應提升材料移除率,亦不損及低電極消
耗的優點。

利用quasi-explosion mode 可減少加工時
間。

使用 intake method 可增加quasi-explosion
mode 的加工精度。
21