Transcript Introduction to Static Routing Pertemuan 11 1

Pertemuan 11
Introduction to Static Routing
1
Discussion Topics
•
•
•
•
•
•
Introducing routing
Static route operation
Configuring static routes
Configuring default route forwarding
Verifying static route configuration
Troubleshooting static route configuration
2
Route Types
Specifying Outgoing Interface
Specifying the Next-hop IP
Address
Configuring Static Routes
Non-directly Connected
Networks
Verifying Static Route
Configuration
• The command show running-config
is used to view the active configuration in
RAM to verify that the static route was
entered correctly.
• The show ip route command is used
to make sure that the static route is
present in the routing table
The show ip route Command
Output
Troubleshooting Static Route
Configuration
• The show interfaces command
• The ping command
• The traceroute command
The ping and traceroute
Commands