Transcript Introduction; Units (1.1); Basic Quantities (1.2); Circuit Elements (1.3) Dr. Holbert January 18, 2006 ECE201 Lect-1

Introduction; Units (1.1);
Basic Quantities (1.2);
Circuit Elements (1.3)
Dr. Holbert
January 18, 2006
ECE201 Lect-1
1
Basic Electrical Quantities
• Basic quantities: current, voltage and power
– Current: time rate of change of electric charge
I = dq/dt
1 Amp = 1 Coulomb/sec
– Voltage: electromotive force or potential, V
1 Volt = 1 Joule/Coulomb = 1 N·m/coulomb
– Power:
P=IV
1 Watt = 1 Volt·Amp = 1 Joule/sec
ECE201 Lect-1
2
Current, I
• Normally we talk about the movement of positive
charges although we know that, in general, in
metallic conductors current results from electron
motion (conventionally positive flow)
• The sign of the current indicates the direction of
flow
• Types of current:
– direct current (dc): batteries and some special
generators
– alternating current (ac): household current which varies
with time
ECE201 Lect-1
3
Voltage, V
• Voltage is the difference in energy level of a
unit charge located at each of two points in
a circuit, and therefore, represents the
energy required to move the unit charge
from one point to the other
ECE201 Lect-1
4
Sign Convention
• Passive sign convention : current should
enter the positive voltage terminal
I
+
Circuit Element
–
• Consequence for P = I V
– Positive (+) Power: element absorbs power
– Negative (-) Power: element supplies power
ECE201 Lect-1
5
Electrical Analogies (Physical)
Electrical
Hydraulic
Base
Charge (q)
Mass (m)
Flow
Current (I)
Fluid flow (G)
Potential
Voltage (V)
Pressure (p)
P=IV
P=Gp
Power
ECE201 Lect-1
6
Class Examples
• Learning Extension E1.1
• Learning Extension E1.2
ECE201 Lect-1
7
Active vs. Passive Elements
• Active elements can generate energy
– Batteries
– Voltage and current sources
• Passive elements cannot generate energy
– Resistors
– Capacitors and Inductors (but CAN store
energy)
ECE201 Lect-1
8
Independent vs. Dependent
Sources
An independent source (voltage or current)
may be DC (constant) or time-varying, but
does not depend on other voltages or currents
in the circuit.
+
–
The dependent source magnitude is a function
of another voltage or current in the circuit.
ECE201 Lect-1
9
Dependent Voltage Sources
6Vx
+
–
6000Ix
+
–
Voltage
Controlled
Voltage Source
Current
Controlled
Voltage Source
ECE201 Lect-1
10
Dependent Current Sources
0.006Vx
Voltage
Controlled
Current Source
6Ix
Current
Controlled
Current Source
ECE201 Lect-1
11
Class Examples
• Learning Extension E1.3
• Learning Extension E1.4(a)
• Learning Extension E1.5
ECE201 Lect-1
12