Toaster Speed Conversion Kit

Download Report

Transcript Toaster Speed Conversion Kit

Toaster Speed
Conversion Kit
Kit 826-1950 includes:
• New Sprocket
• New Upper Bracket
• New Stickers
• New Ground Wires
• Remove cover.
• Remove compression
knobs.
• Remove side panel.
• The bracket and
the sprocket
shown by arrows
are changed with
this kit.
• Ensure bolt
securing large
drive gear is
positioned so it is
accessible.
• Remove power
from unit.
• Cut wire tie on
diagonal brace and
remove brace.
• Depress idler and
lift chain from
sprockets.
• If too tight,
remove upper idler
bracket to remove
chain.
• Loosen bolt securing
drive sprocket and use a
straight-arm wheel puller
to remove the sprocket.
• Remove upper idler
bracket, remove
sprocket from bracket
and install on new
bracket.
• The new drive
sprocket, shown here
on top of the older
drive sprocket, is
smaller and slows the
toaster slightly. Install
it in the same plane as
the spring-loaded
idler.
• Install the new ground wires and
route from the ground position near
the idler bracket to the higher
ground position (shown above).
• Route the
chain as shown
and loop onto
the upper idler
before
positioning the
upper idler
bracket on its
mounting studs.
• Bolt the new
upper idler
bracket into
place.
• Cut the provided bushings with wire dikes.
• Slip the cut
bushing over
an element
wire...
• … and press it into place on
the housing protecting the
element ends.
• Replace diagonal brace and
attach wiring with a wire tie,
ensuring it stays out of the
drive train.
• Apply the new crown and heel sticker to the bun guide.
• Replace the side and
apply the new buncompression sticker and
replace the knobs.
• Attach the unit to power.
• Ensure proper operation.
• File all paperwork, being
careful to include the serial
numbers of the toasters
modified and the store
address.