Seismic Methods Geoph 465/565 ERB 2104 Lecture 2 – Sept 6
Download
Report
Transcript Seismic Methods Geoph 465/565 ERB 2104 Lecture 2 – Sept 6
Lee M. Liberty
Associate Research Professor
Boise State University
P-wave and S-wave analysis of borehole data
March 17 –
◦ Alex - the spectrum of seismology
◦ Kyle
◦ Hank
March 19 –
◦ Gabe ◦ Phippipa - beam forming
◦ Brian – stress fields and why we care
March 21 - Megan
Multicomponent
analyses
For isotropic conditions, multicomponent data for a reflection
on an oblique line with steep dip might be equally active on
the X, Y and Z components.
Each dot in the hodogram plot shows the amplitude on
component 1 plotted against the amplitude on component 2
for each time sample of the signal.
New axes after rotation to maximize energy on component 1.
Hodogram
analysis
From Pugin et al., 2009
From Pugin et al., 2009
2-c hammer
shots on an
asphalt
surface
The process by which seismic events (changes in
energy) are geometrically re-located in either
space or time to the location the event occurred
in the subsurface rather than the location that it
was recorded at the surface, thereby creating an
accurate image of the subsurface.
-Migration is dependent on
seismic velocity
-seismic profile (or gather)
length must include the
reflected energy
Point source
in subsurface
Diffraction on
zero offset
seismic
section with
velocity of
overlying
medium
t2 = 02 +4x2/V2RMS
Migration steepens reflectors
Migration shortens reflectors
Migration moves reflectors updip
Danbom Geophy sics
Schematic that shows the imaging problem for a vertical fault.
In an un-migrated time section reflectors do not represent the true
subsurface geometry.
•See examples below…
(C)
(A)
From Kearey et al., 2002
Seafloor
Dipping
reflectors
Time section
(A) a syncline on the seafloor is
imaged as a “bow-time section
Bow-tie effect
(B)
Time section
Geological
Crosssection
(B) The addition of diffractions from
the end of reflectors results in a very
complex time section
(B) A dipping reflector is shallower in
a time section
Unmigrated
image with
bowtie
reflectors
Migrated
image
Original image
Unmigrated image
Wave-equation migration (computationally
expensive
◦ Spread every data point along the wavefront
◦ (Huygens Principal)
◦ Or downward continue the wavefront
(usually finite Finite-difference)
the most exact pursuit of migration – assuming the
use the ‘exact’ subsurface velocity field
Kirchoff migration (intermediate speed)
◦ Sum diffraction curves
F-k (Stolt) migration (fastest)
◦ Remapping in frequency-wavenumber domain
◦ assume constant velocity (or simple gradient)
Shot records
Velan
NMO
stack
Velan
NMO
stack
Velan
NMO
DMO
Dip moveout
shots
Stacked section
Stacked section
Inverse NMO
Velan
NMO
stack
Time migration
Time migrated
section
Depth
migration
DMO stack
Migration;
Time-depth
conversion
Time-depth
conversion
Time migrated
Depth section
Velan;
Prestack
Depth migration
Depth migrated
section
Prestack
Migrated
section
Prestack migrated
Depth section
Migration after stack:
Migration before stack:
◦ Each trace on a stacked section is a “zero-offset”
trace (coincident source and receiver)
◦ Migration is done by spreading each data point in
a nearly spherical wavefront
◦ Midpoint “smearing” on dipping events reduces
resolution
◦ Assumes no significant lateral velocity gradient
◦ Each trace has a different source and receiver
location
◦ Migration is done by spreading each data point in
an eliptical wavefront
◦ Must migrate “CMP fold” times as many traces
◦ Can give a “perfect” migration
Also known as “partial prestack migration”
Cheap alternative to true prestack migration
Breaks prestack migration into 2 steps:
[CMP sort, velocity analysis, NMO]
◦ Partial migration (DMO) on shot records
[remove NMO, CMP sort, velocity analysis, NMO,
stack]
◦ Migration of stacked section
General discussion of the term ‘Dip Moveout’ (DMO)
DMO is a seismic processing operation to correct for the fact that,
for dipping reflections, the traces of a CMP gather do not involve
a common reflecting point – e.g., line 1.
velocity analysis – fast velocities
Danbom Geophy sics
velocity analysis – slow velocities
Danbom Geophy sics
DMO corrected velocity analysis
Danbom Geophy sics
Sum
Diffractions
(Kirchoff)
Migration in the F-K domain
the quickest migration method
assume constant velocity (vertical velocity can be
accommodated)
accurate to 90o
works by transforming the data to the FK domain,
applying the migration equation tan(a )=sin(b )
which shifts the data vertically on the frequency
axis only to transform the data to the migrated dip.
Following inverse transformation the migrated
solution is obtained.