Transcript Understanding Weather and Climate Ch 11

Understanding Weather
and Climate
3rd Edition
Edward Aguado and James E. Burt
Anthony J. Vega
Part 4. Disturbances
Chapter 11
Lightning, Thunder, and Tornadoes
Introduction
Thunderstorms occur about 40,000 times per day over the
globe
Each of these produces a considerable amount of lightning
and a few produce tornadoes
Processes of Lightning Formation
• Cloud-to-cloud lightning, the most frequent type, occurs when
discharges of electricity occur within a particular cloud or between
clouds
• This is also called sheet lightning as the sky is typically uniformly lit
while the stroke is buried within the cloud
• Cloud-to-ground lightning begins when negative charges build in a
cloud base
• These charges eventually discharge onto the positively charged
ground
• The ground is typically negatively charged but the cloud charge
offsets this by repelling electrons below
Charge Separation
• Electrical charges must separate within portions of a cloud for
lightning to initiate
• Positive charges typically accumulate in the upper areas of the cloud
while negatively charged particles aggregate in lower portions
• Charge separation occurs in relation to ice crystals, the lighter
positively charged crystals inhabit the upper reaches of the cloud
while heavier crystals migrate to lower portions
• This thermoelectric effect is still being researched
• Another process, induction, may contribute to charge separation
• Induction is based on the fact that opposite charges attract such that
the top of falling ice pellets will be negatively charged due to the
positive charge of the upper atmosphere
• Finer ice crystals or small drops acquiring a positive charge, move to
the upper cloud area while the heavier pellets stabilize in the lower
areas of the cloud
Charge separation in a cloud leading to lightning
A strong electrical field occurs prior to lightning
Leaders, Strokes, and Flashes
• For cloud-to-ground lightning to occur, a stepped-leader must emanate
from the cloud base
• The leader is essentially an ionized particle chamber about 10 cm (4
in) in diameter which forks repeatedly from a main channel
• Each section travels about 50 m in a microsecond
• The sections continue until contact is made with an unlike charged
area (the ground)
• Upon connection, electrons flow resulting in an illuminated return
stroke
• Although the electrical current is from the cloud to the ground, the
return stroke is in the opposite direction
• Air in the conducting channel heats to about 30,000K (54,000oF)
• Usually more than one stroke is needed to neutralize all negative ions
• Another leader, or dart leader, is initiated and a return stroke follows
• The process is repeated about 4-5 times on average
• Individual strokes are almost impossible to detect but the entire
lightning flash, a combination of all strokes, typically flickers
Development of lightning
Types of Lightning
• There are many types of lightning
• Ball lightning may be the most unusual
– A round mass of electrified air about as large as a basketball
– Displays rather bizarre behavior
• St. Elmo’s fire refers to tall objects glowing as ionization occurs in
the air around them
• Sprites are large, short duration electrical bursts from the tops of
clouds producing lightning below
– Rather rare events occurring in only about 1% of all lightning events
• Blue jets are similar to sprites in that upward electrical bursts occur
from active thunderstorm regions
Thunder
• The rapid expansion of air associated with a lightning stroke causes
thunder
• the slower speed of sound, with reference to light, causes a lag
between the stroke and the resulting thunder
Above: A sprite
Left: A blue jet
• To determine the distance in km, count the seconds between the
stroke and thunder and divide by 3 (by 5 to determine distance in
miles)
• Lightning without thunder being heard is sometimes called heat
lightning
– Thunder is produced but the stroke is too far away to reach an observer
• Rumbling thunder is typically caused by sound echoing off
topographic features and buildings
Lightning Safety
• The safest area to be during a thunderstorm is indoors
• One should not be in contact with electrical appliances or telephones
• Automobiles are also safe as electricity will be conducted to the
ground through the shell and not the interior
Thunderstorms: Self-Extinguishing vs. Self Propagating
• The vast majority of thunderstorms are of the air mass variety,
meaning that they are localized short lived phenomena
• Air mass thunderstorms usually do not become severe
– Spatially and temporally limited
– Each is comprised of a number of individual cells with each undergoing
a particular life cycle
• The life cycle begins with the cumulus stage
– This begins with differential heating of the Earth’s surface leading to
parcel formation and rising air
– Only updrafts are present as air rises and adiabatically cools
– Eventually, enough water vapor will be present to sustain vertical cloud
development which occurs between 5-20 m/sec (10-45 mph)
• The mature stage is marked by precipitation and the presence of both
up and down drafts
– Downdrafts are initiated through frictional drag associated with falling
precipitation
– This is also a time of lightning and thunder
– Cloud tops are formed where the atmosphere is stable
– An anvil head may occur as high speed winds blow ice crystals
downstream
– Updrafts dominate the interior portions of the storm while downdrafts
occur toward the edges
– Entrainment occurring along the cloud edges discourages lifting in those
areas, leading to well defined cloud edges
• The dissipative stage occurs when downdrafts dominate airflow
within the thunderstorms
– This suppresses updrafts and the addition of water vapor
– Precipitation then ceases and the cloud eventually evaporates
– Overall, only about 20% of the available moisture falls as precipitation,
the rest evaporates
– each tower of a typical cumulonimbus cloud represents an individual cell
– Fuzzy cloud edges indicate older portions of the storm which are
glaciated (composed of ice crystals)
Air mass thunderstorm lifecycle
• Severe Thunderstorms
– Occur when winds exceed 93 km/hr (58 mph), have large hailstones (1.9
cm; 0.75 in) or produce tornadoes
– These systems differ from air mass thunderstorms in that the up and
downdrafts support each other to intensify the storm
– Particular atmospheric conditions must persist across the mesoscale (101000 km) for severe thunderstorms to develop
– Usually occur in groups over fairly large areas
– Clusters are deemed mesoscale convective systems (MCSs), as squall
lines, or as circular clusters called mesoscale convective complex’s
(MCCs)
– Individual storms develop in concert in a situation which propagates
additional thunderstorms
– Many MCSs have life spans from up to 12 hrs to several days
– Systems may account for as much as 60% of the total annual rainfall
– Severe thunderstorms may also form from individual supercells which
contain only one updraft (supercells may also be a part of an MCS)
– Atmospheric conditions supporting severe thunderstorms include wind
shear, high water vapor content in lower portions of the troposphere, a
forcing mechanism, and potential instability
• Mesoscale Convective Complexes
– MCCs account for the greatest amount of severe weather in the U.S. and
Canada
– Roughly circular clusters of thunderstorms which are self propagating in
that individual cells create downdrafts which interact to form new cells
– Colder, denser downdrafts spread across the surface and help force
warm, moist surface air aloft
– This outflow boundary initiates a new cell, most often along the
southern edge of the MCC as the downdrafts intermingle with a usual
stream of warm, moist surface air from the south
– The entire system typically propagates toward the east along with the
associated upper air wind
• Squall Line Thunderstorms
– Differ from MCCs in that thunderstorms are usually linear
– Bands may be as long as 500 km (300 mi) usually about 300-500 km
(180-300 mi) in advance of cold fronts
– Strong vertical wind shear is essential to the development of these
prefrontal waves as it ensures that updrafts will be positioned ahead of
the downdrafts
– This feeds moisture into the system which is also aided by gust front
propagation ahead of the situation
A squall line (MCS)
An MCC over South Dakota
A radar image of
outflow boundaries
Thunderstorm movement in an MCC
Wind shear and vertical
motions in a squall line
thunderstorm
• Supercell Storms
– Although supercells consist of a single cell they are typically more
violent than MCCs or squall lines
– Strong wind shear is responsible for wrapping up and downdrafts around
each other in these tornado producers
– This creates large-scale rotation which is typically absent from MCCs
and squall lines
– Similar to MCCs and squalls, supercell downdrafts aid the intensification
of the system through enhanced uplift of warm, moist air
– Doppler radar is used to reveal areas of rotation
– Radar hooks signify tornado formation
– Radar may also reveal a large vacant region of the storm located in the
southeast quadrant
– This vault is the location of the warm updraft and is comprised of
droplets too small to be detected
Right: Internal structure of a supercell
Below: Organization of a supercell as
seen on a radar image (actual radar, below
right)
Geographic and Temporal Distribution of Thunderstorms
• Thunderstorms develop where moist air is forced aloft
• Occurs frequently in the tropics, nearly daily in some locations
• In the U.S., most frequent region is the Gulf South
– Absolute peak in Florida as the state is a land protrusion into warm
waters
Tornadoes
• Areas of rapid, rotating, lifting winds beneath cumulonimbus clouds
• Strong counterclockwise winds originate in relation to large pressure
gradients over small spatial scales
• Pressure differences may be as much as 100 mb over a few tenths of
km
• Tornado Characteristics and Dimensions
– Typically have diameters of about 100 yards but may be much larger
– Usually a short lived phenomena lasting only a few minutes, but some
have lasted for hours
– Movement is generally about 50km/hr (30 mph) over an areas about 3-4
km (2-2.5 mi) long
– Winds may be as low as 65 km/hr (40 mph) or as high as 450 km/hr (280
mph)
• Tornado Formation
– Common to frontal boundaries, squall lines, MCCs, supercells and
tropical cyclones
– Most violent tornadoes are associated with supercells
• Supercell Tornado Development
– Begins with the development of a mesocyclone
– A large rotation region within the cloud interior which develops in
the presence of vertical wind shear
– From the surface aloft, winds shift from southerly to westerly while
speed increases
– Strong updrafts tilt the rotation region to a vertical position while the
diameter decreases
– With a spatial decrease comes an increase in speed as dictated by the
conservation of angular momentum
– The rotating air column will then penetrate the cloud base producing a
wall cloud
– From the wall cloud, a narrow rotating region, the funnel cloud, emerges
on a path to the surface
– Doppler radar detects mesocyclone development leading to increased
warning times
– Only about 1/2 of all mesocyclones actually spawn a tornado
A supercell with tornado
Mesocyclone formation from a tilted horizontal vortex
A tornado producing supercell
A non-supercell tornado develops
where the outflows from separate
storm downdrafts cause convergence
Tornado development along a convergence boundary
• Nonsupercell Tornado Development
– May be associated with development from the interaction of outflow
boundaries between two or more thunderstorms
– Another development mechanism may be related to strong convection
along a convergence zone
• The Location and Timing of Tornadoes
– The U.S. is the world leader in tornado production
– This results from the regular interaction between extremely unlike air
masses which originate in very high latitudes and over the Gulf of
Mexico
– The absence of topographic barriers ensures regular mixing and the
production of violent storm systems
– The vast majority occur in Tornado Alley, a region from the southern
Plains to the lower Great Lakes
– Texas has the highest tornado frequency of any state
– May is the month of highest frequency while June is a close second
– Many states show tornado peaks during different months, however, late
spring is the time of greatest overall activity
Global tornado frequencies
Annual U.S. tornado
frequencies
Monthly tornado frequencies for the U.S. (left)
and by state (below)
• Tornado Damage
– Winds, not pressure change, cause the greatest amount of damage
– Flying debris causes the greatest amount of injuries
– Some tornadoes have multiple suction vortices which may account for
rather selective damage patterns
– Tornadoes are classified using the Fujita scale which ranks tornadoes
based on damage
– Of the scale levels (0-5), nearly 3/4 of all tornadoes fall into the weak
categories (0-1) while 25% are classified as being strong (2-3), and only
1% are deemed violent (4-5)
– Violent tornadoes are capable of nearly catastrophic damage
• Fatalities
–
–
–
–
due to their small spatial scales, tornadoes kill relatively few people
On average 760 tornadoes occur in the U.S. yet only 91 people are killed
88% of all tornadoes kill no one
Most fatalities occur in associated with a few large tornadoes rather than
with many smaller ones
– Only about 1% of all tornadoes are responsible for over 2/3 of all deaths
– Mobile homes and autos are the sites of many deaths
– The safest place to be during a tornado is in a building basement
• Watches and Warnings
– A weather watch (severe thunderstorm, tornado, etc.) states that
atmospheric conditions are favorable for the development of a particular
severe weather event
– A warning states that severe weather is imminent and precautions should
be taken immediately
– Because tornadoes develop rapidly and are of short duration, may times a
warning may be disseminated only after a tornado has touched down
• Waterspouts
– Similar to tornadoes except that they develop over warm waters and are
usually smaller and weaker than tornadoes
– Usually form in association with cumulus congestus clouds and although
they are over water, the spouts are composed of water vapor condensing
into the low pressure area
End of Chapter 11
Understanding Weather and
Climate
3rd Edition
Edward Aguado and James E. Burt