スライド 1

Download Report

Transcript スライド 1

Water purification using pulsed-discharge plasma
Yasushi
1
Miyazaki ,
Kohki
1,2
Satoh and
Hidenori
1
Itoh
1Department
of Electrical and Electronic Engineering, Muroran Institute of Technology, 27-1 Mizumoto, Muroran 050-8585, Japan
2Center of Environmental Science and Disaster Mitigation for Advanced Research, Muroran Institute of Technology, 27-1 Mizumoto, Muroran 050-8585, Japan
E-mail : [email protected]
1. INTRODUCTION
2. APPARATUS&CONDITIONS
Electrode : A multi-needle and a plane
Background
electrodes
• Advanced Oxidation Processes[1](AOPs), have attracted the attention of many researchers as effective methods for
purifying water polluted by non-degradable hazardous substances, such as dioxin, PCB, etc.
• A multi-needle electrode :
 4 stainless-steel needles are arranged on a
brass plate with mutual distances of 10mm.
AOPs[1]
• A plane electrode :
 The methods for decomposing hazardous chemical substances in aqueous solution, using oxidizers (OH,O3 etc),
which are generated by diverse ways.
 A water bath made of plastic, which has the
dimensions of
144mm×104mm×16mm(depth), is placed
under the multi-needle electrode.
ozone-UV oxidation,photocatalytic oxidation,wet oxidation,pulsed discharge
 A duralumin plate(130mm× 90mm×3mm) is
put in the water bath, and the plate is earsed.
Pulsed discharge[2][3]
• Gap length :
 Release the stored energy in a short time, therefore, the energy is compressed in
terms of time. (high-energy density ;20kV,70A,500ns)
 4mm(A distance between the multi-needle
electrode and the surface of the test liquid).
Effective
decomposition can
be expected
 High energy electron can be generated, because pulse rise time is very short.
 The species that have high oxidation potential, such as OH, O, O3, H2O2 etc., are
produced efficiently, with high energy electron.
Discharge chamber
• Dimensions of 280mm×280mm×125mm
H.V. pulse generator : Blumlein
 Chemical substances are decomposed directly, by high energy electron.
• A high-voltage pulse generated by a Blumlein
generator, which has two coaxial transmission lines,
is applied to the multi-needle electrode to generate
the pulsed-discharge plasma.
Recent approaches
• The species that have high oxidation potential, such as OH, O, O3 etc., are produced in pulsed-discharge plasma
generated above a water surface[2].
• The coaxial transmission lines are charged up
+14.14kV.
Objective
• We investigated the decomposition characteristics of aqueous phenol solution (test liquid), which is used as a
substitution of polluted water, by using pulsed discharge, with the different humidity and composition of the
background gas.
Phenol
Dioxin
• The pulse repetition rate is 20pps(pulse per second).
Background gas : N2 (99.99%) and O2 (99.5%)
•
Mixture rate are N2 : O2 = 0:100, 20:80, 50:50, 80:20 and 100:0
 Substitution of Polluted water : Aqueous phenol solution
•
•
Dioxin is decomposed by cleavage of the aromatic
ring and dissociation of C-O bond[4].
Initial concentration : 300ppm
Initial volume : 70g
Concentration measurements of phenol : Gas chromatography
•
•
• Phenol has the aromatic ring.
→A substitution of dioxin
The concentration of phenol are measured following 15min-discharge,and this production is repeated four times.
The concentration of phenol are measured by using a gas chromatography (Shimadzu,GC-14A).
Measurement of voltage & current
• Low concentration of phenol has no affect on the
human body.
•
Discharge voltage and discharge current are measured by high-voltage probe (Tektronix P6015A) and digital oscilloscope
(Yokogawwa,DL1620).
3.RESULTS&DISCUSSION
(1) The characteristics of applied HV pulse
0
0
-10
current [A]
-50
Current
 500ns in width
 70A at maximum
1.5
1.0
Power
 500ns in width
 About 1.5MW during
first pulse
0.5
0.0
-20
-100
0
1
2
3
4
-0.5
0
5
1
time [s]
2
3
time [s]
4
5
50
40
H2O  e  OH  H
30
0
Input energy
 0.7 J/pulse (14 J/s)
0.0
0.5
1.0
1.5
2.0
2.5
operating energy density [J/ g/ ppm]
The discharge in N2-O2 mixture[1]
N2  e  2N  e
O2  e  2O  e
O  O2  M  O3  M
N  O  NO
N O  O  NO2
O3  NO  NO2  O2
• Following reactions can be
induced in the pulsed-discharge
plasma with the background gas
consisting of N2 and O2, in
addition to the reaction of OH
production in eq.(1).
 Three tendencies are shown in the variations of phenol
decomposition rate.
 The decomposition rates at 60min are 56% in pure O2,
42% in pure N2, and 38% in N2-O2 mixture.
…… (2)
…… (3)
…… (4)
…… (5)
…… (6)
…… (7)
40
0
56%
4needles
(low humidity, negative)
>
42%
>
in N2-O2
mixture
38%
0
0.0
0.5
1.0
1.5
2.0
2.5
operating energy density [J/ g/ ppm]
 in O2
This is due to the generation of O and O3, produced by eqs.(3)and(4), in addition to
OH production by eq.(1).
80
100
120
50
0
100
80
40
60
30
40
20
20
10
40
60
80
100
70
60
40
20
60
120
50
100
40
80
30
60
20
40
10
20
0
100
0
80
20
140
NOx
NO
NO2
60
0
100
The phenol decomposition rate is the highest.
60
O2[%]
0
0
80
60
40
20
0
N2[%]
N2[%]
backgroud gas
 in N2
The next highest decomposition rate is obtained, though no O3 is produced.
This is due to OH radicals, which are additionally produced in the reaction eq.(8),
from nitrogen molecule in the metastable state (N2(A))[3].
N2 (A)  H2O  OH  N2  H
OH
…… (8)
N2(A)
The decomposition rates in N2-O2 show lower values,
in N2-O2
mixture
The NO decomposes O3 produced by pulsed discharge, by the process shown in eq.(7).
Therefore, O3 cannot contribute to the decomposition of phenol.
O atoms are consumed for the reactions of NO and NO2 production in eqs.(5)and(6)
Therefore, O3 production shown in eq.(4) is inhibited.
O2
N2
N2-O2 mixture
○
○
○
×
◎
Oxidation potential[5]
Oxidant
○
Oxidation
potential [V]
O3
◎
×
×~△
O
◎
×
△
NOx
×
△
○
OH
2.80
O
2.42
O3
2.07
◎ produced much ○ produced △ produced little ×not produced
4. CONCLUSIONS
We investigated the decomposition characterisitics of aqueous phenol solution, by using pulsed discharge, with the different humidity and decomposition of the background gas.
The decomposition rate increases at high humidity (80%), therefore, the decomposition of phenol is influenced H2O in the gaseous phase.
The difference of the decomposition rate for different humidity is only about 5%, therefore the decomposition rate slightly increases as to humidity of the background gas.
The phenol decomposition rate changes by 20%, with the different composition of the background gas.
If OH production by eq.(1) is induced in similar proportion with the different composition of background gas, effective species to decompose phenol are OH, O3 and N2(A) in order of priority.
Reference
[1]
[2]
[3]
[4]
[5]
W.F.L.M.Hoben et al : Technische Universiteit Eindhoben (2000)
P. Lukes et al : J.Phys.D:Appl.Phy.,38.,409 (2005)
Kimu et al :NATIONAL CONVENTION RECORD I.E.E. JAPAN, 068, 85 (2006)
H.Yasui et al: Proceedings of the XIII International Conference on Gas Discharges and their Applications, Vol.2, pp.692(2000)
P. Lukes : INSTITUTE OF PLASMA PHYSICS,AS CR 2001
O3 concentration [ppm]
20
in N2
40
70
decomposition rate [%]
in O2
20
O2[%]
NOx concentration [ppm]
decomposition rate [%]
• The difference of the decomposition rate for different
humidity is only about 5%.
• The decomposition rate slightly increases, as to the
humidity of background gas.
10
80
60
…… (1)
20
(3)The difference of the phenol decomposition rate for different composition of the background gas
N2:O 2 = 0:100
N2:O 2 = 20:80
N2:O 2 = 50:50
N2:O 2 = 80:20
N2:O 2 = 100:0
 The decomposition rate increases at high humidity, and
this is probably due to the increase of OH, produced by
eq.(1).
high humidity (80%)
low humidity (20%)
decomposition rate [%]
voltage [kV]
50
10
electric power [MW]
Vg
Ig
20
60
decomposition rate [%]
2.0
100
(2) The difference of the phenol decomposition rate for different humidity
Voltage
 500ns in width
 20kV at maximum