Transcript Introduction to ANSYS 6.0 Part 2
Workshop Supplement
Introduction to ANSYS 6.0 Part 2
Workshop Supplement Introduction to ANSYS, Part 2
Inventory Number: 001572 First Edition ANSYS Release: 6.0
Published Date: October 30, 2001 Registered Trademarks:
ANSYS® is a registered trademark of SAS IP Inc.
All other product names mentioned in this manual are trademarks or registered trademarks of their respective manufacturers.
Disclaimer Notice:
This document has been reviewed and approved in accordance with the ANSYS, Inc. Documentation Review and Approval Procedures. “This ANSYS Inc. software product (the Program) and program documentation (Documentation) are furnished by ANSYS, Inc. under an ANSYS Software License Agreement that contains provisions concerning non-disclosure, copying, length and nature of use, warranties, disclaimers and remedies, and other provisions. The Program and Documentation may be used or copied only in accordance with the terms of that License Agreement.”
Copyright © 2001 SAS IP, Inc.
Proprietary data. Unauthorized use, distribution, or duplication is prohibited.
All Rights Reserved.
Introduction to ANSYS 6.0 - Part 2 Table of Contents
Workshop Supplement
1.
Array Parameters
Axisymmetric Wheel W1-1
2.
Coupling & Constraint Equations
A.
B.
C.
Impeller Blade (Coupling) Turbine Blade (Constraint Equations) Swaybar (Rigid Regions) W2-1 W2-17 W2-27
3.
Working with Elements
Bolt Torque (Surface Effect Elements) W3-1
4.
Beam Modeling
Building Frame
5.
Submodeling
Crank Shaft W4-1 W5-1
6.
Modal Analysis
U-Bracket W6-1
7.
Introduction to Nonlinear Analysis
Arched Beam W7-1
8.
Bonded Contact
Swaybar W8-1
9.
Macro Basics
Verifying Pressures W9-1
10. Appendix A
Input Files for Workshop Exercises A-1 *
All workshops were run and verified using the first release of ANSYS 6.0
October 30, 2001 Inventory #001572 WS-TOC-3