Transcript Document
MCS-TOUCHSCREENS www.mcscontrols.com MCS-TOUCH-7 FRONT BACK NEW FOR 2015 High Resolution (1280 x 800) LCD Display with LED Backlighting MCS-TOUCH-15.4 FRONT BACK ON-SCREEN KEYPAD MCS-CONNECT and MCS-GRAPHICS provides both graphics and service mode The MCS-TOUCH-7 and TOUCH-15.4 are new touchscreen interfaces designed to simplify user access with the MCS-Magnum and MCS-MicroMag utilizing MCS-Connect to provide both graphics and service mode access to technicians. Information and graphics on the MCS-TOUCH-7 and MCS-TOUCH-15.4 are shown on a high resolution (1280x800) LCD display with LED backlighting, which will guarantee long-life operation. The MCS-TOUCH-7 and 15.4 are suitable for installation for both indoor and outdoor applications. Utilizing a gasket for an environment seal provides the unit with a NEMA 4 rating. MCS-TOUCHSCREEN MOTHERBOARD - FRONT 7in LCD connector 4 GB EMMC Flash Memory 15.4IN LCD Connector 800 MHZ i.MX6 ARM Micro 5 wire connection 15.4 Touchscreen RTC Battery mPCIe Expansion slot 1 GB DDR3 Memory MICRO SD Slot 2 - USB Ports 2.0 Ethernet Port 4 wire connection 7in Touchscreen Serial Console Port 3 - RS 485 Communication Ports +12 V DC Power Input MCS-TOUCHSCREEN MOTHERBOARD - BACK 1 USB Port On-the-Go INCLUDED COMPONENTS 12 VDC - 50W Single Output Power Supply for Touchscreen Resistant to short circuiting, overloading and over voltage Operating temperature up to 700C Ethernet Crossover Cable 5ft CAT 5e Crossover Patch Cord Orange DESKTOP WITH COMPANY GRAPHIC SETTING UP THE NETWORK Click Options to set Static & Dynamic IP address Click the key shown and the network manager will appear as shown in this screen shot Editing Wired Connection – Static Address Click IP4 Settings to change Network Settings Static IP, Netmask & Gateway Address Set to Manual for Static IP or Auto DHCP for Dynamic Click Add to add a Static IP Enter Static IP, Netmask & Gateway Address Click to save MCS-CONNECT SCREEN Click Setup to move to the MCS-CONNECT setup screen Click to display the MCS-CONNECT main screen MCS-PC CONNECT Setup Screen Local COM Port Choose 1 to 4 COM PORTS: RS485 1 = 1 RS485 2 = 2 RS485 3 = 3 USB-RS485 = 4 Click to save OPENING THE ON-SCREEN TOUCH KEYBOARD Click this key to see on-screen Keyboard DIRECTORY FOR MCS FOLDERS Autostart boot config file runs in background to start MCS-CONNECT Click this key to see MCS Folders BOOT CONFIG FILE STARTING MCS CONNECT File shows MCS-TOUCHSCREEN Boot Config file starting MCS-CONNECT GETTING TO THE MICRO CONTROL WEBSITE SOFTWARE PAGE Click this key to go to the MCS website for software updates The MCS-TOUCH-7 and 15 makes it easy for the user to manage more complex installation diagrams, without losing the overall view of the installation, as well as ensuring that the pages can be browsed in a fast and straightforward manner. Photos below and on the next page are actual screen shots using MCS-CONNECT and MCS-GRAPHICS. MCS GRAPHICS The MCS-TOUCH-7 and 15.4 can connect to up to 60 MCS Controllers at once and supports RS485 or Ethernet networking. MCS-TOUCH – CONNECTION RS-485 TO ONE MCS-MAGNUM MCS-TOUCH – CONNECTION ETHERNET TO ONE MCS-MAGNUM MCS-TOUCH – CONNECTION ETHERNET TO MULTIPLE MCS-MAGNUMS For additional information please visit our website www.mcscontrols.com Or call MCS at 239-694-0089