Transcript Folie 1
WLM - SYSTEM
Network survey and leak zone detection … Reducing water loss sustainable … Detecting leaks immediately ...
MWM – Martinek Water Management GmbH Mozartstraße 23 A – 6845 Hohenems Austria Tel.: Fax : E – Mail : Internet : +43 5576 75510 +43 5576 78170 [email protected]
www.martinek.org
Cost effective chamber installation
•
Installation without any interruption
•
Manufactured by HAWLE Armaturen GmbH
•
Easy installation and dismantling
•
No chamber necessary; just a street cap
Installation of a pipe saddle
•Installation like a house connection •Use a 38mm driller
Installation of the covering pipe
• This part is available in length from 1 to 2,5 m (extra sizes possible) • Length can be cut on site adapt to the local situation
Installation of WLM-Sensor
• Cable will be put through the extension of the sensor and plugged to it.
(all connections are IP68 up to 10m) • The extension can also be cut on site to the needed length
Top of the extension
• Everything will be covered to avoid water entrance • A clamp ring will be fixed on the extension for the right depth of the sensor in the pipe
Install the sensor under pressure
• A special tool will be used to install the sensor under pressure • Safety has first priority!
•Installation is finished
Only a small street cap
• Only a small street cap will be on the top • Highly vandalism protected!
WLM-System
Connection to a street light Aerial at the top of a street light Installation in a street cap: 12 V charger, modem battery.
Up to ca. 15 m