Transcript Document

Decontaminate Yourself and
Individual Equipment Using
Chemical Decontamination Kits
031-503-1013
Presented by:
TrainingNCO.com
Conditions:
 You are at mission-oriented protective
posture ( MOPP ) 2 given the assigned
protective mask, protective gloves, a full
canteen of water, a poncho, load-bearing
equipment ( LBE ), assigned decontaminating
kit ( s ), and applicable technical manuals
(TMs). Your skin is contaminated or has been
exposed to chemical agents, or you have
passed through a chemically contaminated
area.
Standards:
 Decontaminate yourself and your individual
equipment using chemical decontaminating
kits. Start the steps to decontaminate your
skin and eyes within 1 minute after you found
they were contaminated. Decontaminate all
exposed skin and your eyes as necessary
before chemical agent symptoms occur.
Decontaminate all personal equipment for
liquid contamination after decontaminating
your skin, face, and eyes.
Performance Steps
1. Assume MOPP3.
2. Decontaminate your skin using the M291
decontaminating kit according to TM 3-4230-229-10.
3. Decontaminate your individual equipment using the
M295 decontaminating kit according to TM 3-4230-23510.
4. Dispose of hazardous waste materials.
Performance Steps
1. Assume MOPP3.
2. Decontaminate your skin using the M291
decontaminating kit according to TM 3-4230-229-10.
3. Decontaminate your individual equipment using the
M295 decontaminating kit according to TM 3-4230-23510.
4. Dispose of hazardous waste materials.
Performance Steps
1. Assume MOPP3.
2. Decontaminate your skin using the M291
decontaminating kit according to TM 3-4230-229-10.
3. Decontaminate your individual equipment using the
M295 decontaminating kit according to TM 3-4230-23510.
4. Dispose of hazardous waste materials.
Danger
 Death or injury may result if you
breathe toxic agents while
decontaminating your face. If you
need to breathe before you finish,
reseal your mask, clear it, check it,
get your breath, and then resume
the decontaminating procedure.
Caution
 The M291 decontaminating kit is
for external use only. Keep
decontaminating powder out of
your eyes, cuts, and wounds. The
decontaminating powder may
slightly irritate your skin or eyes.
Use water to wash the toxic agent
out of your eyes, cuts, or wounds.
Note
 After decontamination with water,
cover exposed cuts or wounds
with appropriate first aid wrap or
bandages before handling the
decontaminating package.
Caution
 Keep the decontaminating powder out
of your eyes, cuts, and wounds. Do
not handle or hold leaking packets
above your head, touch or rub your
eyes with anything that has been in
contact with the decontaminating
powder, or touch your lips or the inside
of your mouth with anything that has
been in contact with the
decontaminating powder
Caution
 Do not attempt to decontaminate a
loaded weapon. Always unload, clear,
and place weapons on safe before
starting decontaminating procedures.
Caution
 Immediate decontaminating techniques
remove only the liquid hazard. Certain
items may still present a vapor hazard.
See your supervisor for unmasking
procedures.
Decontaminate your skin using the M291
decontaminating kit according to TM 3-4230-229-10.
A. Decontaminate your hands, your face
and the inside of your mask.
B. Assume MOPP4.
C. Remove the decontaminating powder
with soap and water when operational
conditions permit.
Performance Steps
1. Assume MOPP3.
2. Decontaminate your skin using the M291
decontaminating kit according to TM 3-4230-229-10.
3. Decontaminate your individual equipment using the
M295 decontaminating kit according to TM 3-4230-23510.
4. Dispose of hazardous waste materials.
Decontaminate your individual equipment using the
M295 decontaminating kit according to TM 3-4230235-10.
a.
Use the first mitt to decontaminate your gloves, the
exposed areas of your mask and hood, your weapon, and
your helmet.
b.
Use the second mitt to decontaminate your LBE and
accessories, your mask carrier, your overboots, and your
gloves again.
c.
Remove the decontaminating powder when operational
conditions permit.
Performance Steps
1. Assume MOPP3.
2. Decontaminate your skin using the M291
decontaminating kit according to TM 3-4230-229-10.
3. Decontaminate your individual equipment using the
M295 decontaminating kit according to TM 3-4230-23510.
4. Dispose of hazardous waste materials.
Dispose of hazardous waste materials.
a.
Dispose of uncontaminated hazardous waste
materials.
b.
Dispose of contaminated hazardous waste materials. Inform
your supervisor of the status of contaminated hazardous
waste.
Dispose of uncontaminated hazardous waste
materials.
1.
Dispose of expended or unserviceable materials
according to federal, state, and local laws; military
regulations and publications; host nation laws (if
more restrictive than United States [U.S.] laws); and
local standing operating procedures (SOPs).
2.
Place used decontaminating materials in a sealed
plastic bag, and label it with the contents (as a
minimum). Give the bag to your supervisor.
Dispose of hazardous waste materials.
a.
Dispose of uncontaminated hazardous waste
materials.
b.
Dispose of contaminated hazardous waste materials. Inform
your supervisor of the status of contaminated hazardous
waste.
Check on Learning
What may result if you breathe toxic agent while
decontaminating your face.
Severe Rash
Injury
Death
Vomiting
Check on Learning
What may result if you breathe toxic agent while
decontaminating your face.
Severe Rash
Injury
Death
Vomiting
Check on Learning
After you decontaminate your hands, your face,
and the inside of your mask what MOPP level
should you be at?
Level 2
Level 3
Level 4
Check on Learning
After you decontaminate your hands, your face,
and the inside of your mask what MOPP level
should you be at?
Level 2
Level 3
Level 4
Check on Learning
The ________ Kit is used to decontaminate the
skin?
M291
M293
M295
Check on Learning
The ________ Kit is used to decontaminate the
skin?
M291
M293
M295
Check on Learning
The second Mitt from the M295 decontaminating
kit is used to decontaminate what?
Your gloves, the exposed areas of your mask
and hood, your weapon, and your helmet.
Your LBE and accessories, your mask carrier,
your over boots, and your gloves
Check on Learning
The second Mitt from the M295 decontaminating
kit is used to decontaminate what?
Your gloves, the exposed areas of your mask
and hood, your weapon, and your helmet.
Your LBE and accessories, your mask carrier,
your over boots, and your gloves again
Performance Steps
1. Assume MOPP3.
2. Decontaminate your skin using the M291
decontaminating kit according to TM 3-4230-229-10.
3. Decontaminate your individual equipment using the
M295 decontaminating kit according to TM 3-4230-23510.
4. Dispose of hazardous waste materials.
Performance Measures
1.
Assume MOPP3.
2.
Decontaminate your skin using the M291 decontaminating
kit according to TM 3-4230-229-10.
3.
Decontaminate your individual equipment using the M295
decontaminating kit according to TM 3-4230-235-10.
4.
Dispose of hazardous waste materials.
Score the soldier GO if all performance measures are passed. Score the soldier
NO GO if any performance measure is failed. If the soldier fails any performance
measure, show him what he did wrong and how to do it correctly.
References
Required
FM 3-5
TM 3-4230-229-10
TM 3-4230-235-10
Decontaminate Yourself and
Individual Equipment Using
Chemical Decontamination Kits
031-503-1013
Presented by:
TrainingNCO.com