Transcript Slide 1

LED PAR30 @ a Glance
Where to Use
•
75W PAR30 Halogen
Equiv.
SGL P/N
97314S
Light output (lumens)
725
Power
15W
Efficacy
48 lpw
CRI
•
•
•
Any SGL recessed 5” or 6” housings and trims qualified
for 75W PAR30, except enclosed shower trim
Wet listed, can be used outdoor in just a par holder
Great performer vs. halogen equivalent
LRG, New catalog and website will list upgrade options
with all compatible fixtures/trims
85
Color Temp*
3000K
Beam angle
40
Life (hours)
50K
Dimmable
Yes
Rating
Wet
1
® 2011 Generation Brands
LED
LED PAR30 @ a Glance
2
® 2011 Generation Brands
LED
Dimmer Compatibility – LED PAR30 97314S, 97414S
Dimmable down to 5% of light output
Make
Models
Lutron
ADRIANI AYLV-600; Commercial Systems QSG-6P, LP-RPM-4A-120, HW/LP-RPM-4U-120; Diva
DV-600, DVLV-600; Interfaces PHP, PHPM-WBX w/DVF-103P; Homeworks HW-RPM-4-U-120,
HxD-6ND; Panel Module CTCL-153P, TTCL-100D, Grafik Eye; Radio Ra RRD-10ND, RRD-6NA;
Stanza SZ-6ND; Lutron RRD-10ND, SZ-6ND, HW-RPM-4A-120, HxD-6ND, S-600PR-WH, DV600PR-WH, TG600PR-WH, Q600P, GL-600, CN-600PWH, DV-603PG, S-600, S-600P, LG-600P, D600PH, TT-300NLH, TG-603PG, DV-600PR-WH
Others
Ace 34050, 3027596; Leviton 6633-PL, 6684, 6631, IPI06-1LX, Legrand DrRD4W
Recommended Number of Lamps per 600W Dimmer*
While an LED lamp may draws as few as 15 watts continuously, it could have an in-rush current spike and should
therefore be treated as a 115W load when sizing dimmers. The recommended number of lamps that should be
used on a typical approved dimmers is as follows.
SGL LED Lamp
LED PAR30
97314S, 97414S
® 2011 Generation Brands
In-Rush Current
Equivalent
Max # of Lamps
per 600 watt Dimmer
115 Watts
5
* Note – Dimmer listing is subject to change. Dimmer compatibility list indicates those dimmers that have been tested and
operate properly under normal conditions. In certain cases, approved dimmers are offered in higher wattage varieties that
are also compliant and allow for further installation of additional lamps if kept within the maximum in-rush current
equivalent noted in the table above. Each application is unique and various factors such as load, common neutrals and
other electrical products on the circuit may cause variance in performance. Consult dimming system manufacturer for
additional support in operation.
1