Transcript Computer-Aided Engineering Design

Computer-Aided Engineering Design
Homework
Assignment 3
Due on September 24
1
The members of the roof truss shown in the accompanying
figure have a cross-sectional area of 21.5 in2 and are made of
Douglas-fir wood with a modulus of elasticity of E=1.9 x 106
lb/in2. Using ANSYS, determine the deflection of each joint,
the stresses in each member, and reaction forces. Also, replace
one of the fixed boundary conditions with rollers and obtain the
stresses in each member. Discuss the difference in results.
250 lb
250 lb
250 lb
250 lb
250 lb
3 ft
8.7 ft
24 ft
2
The members of the truss shown in the accompanying figure
have a cross-sectional area of 2.3 in2 and are made of
aluminum alloy (E=10.0x106 lb/in2). Using hand calculations,
determine the deflection of joint A, the stress in each number,
and reaction forces, verify your results.
D (0, 4, 0)
B (-0.5, 2.0, 2.0)
1000 lb
E (1.0, 2.5, 0)
A (0, 0, 0)
3