Oblique Views

Department of Technological Education

• •

Oblique Projection

The given views show the orthographic views of a mantle clock.

Draw an oblique view with corner X in the given position.

Do not add the hands of the clock to your drawing.

X X Department of Technological Education X

Drawing Oblique Crate

Start the oblique view by drawing a crate to fit the clock into.

In this case the size of the crate will enclose the body of the clock but does not include the clock face. This will be added to the main drawing later.

For Standard Grade drawings the depth of the crate should be drawn at 45 used.

o with the size measured at either full size or half full size. In this case half sizes have been X X Department of Technological Education X

Drawing Clock Top

Draw the top curve of the clock body on the front surface of the crate.

Project the centre of the curve back at 45 the back curve.

o to locate the centre of Draw a 45 o line through each centre to find the tangent points where the curves are joined by straight edges.

X X Department of Technological Education X

Drawing Clock Face

Draw the circle for the face on the front surface of the clock body.

Locate the centre of the clock face at the very front of the drawing.

Remember that the distance in this drawing is half of the full size.

Draw the outside circle and the inside circle of the clock face.

Locate the tangent points on the face circles and add the straight edges required.

X X Department of Technological Education X

Drawing Clock Base

Add the feet details to the drawing.

Remember to use half sizes for any dimensions which are measured along 45 o lines.

X Department of Technological Education X X

Finishing Drawing

To finish the drawing, darken in the outlines of the oblique view.

X Department of Technological Education X X

Department of Technological Education

Alternative Oblique View

At Standard Grade an Oblique View may be drawn with the dimensions on the 45 o angles at full size or half full size.

The two drawings shown here show the different views generated by both methods.

X Oblique view using full sizes (Cavalier Projection) X Oblique view using half full sizes (Cabinet Projection)

PowerPoint Presentation produced for Graphic Communication