Transcript Millipore DI Water Purifier
Millipore DI Water Purifier
Ron Kmak, Zeljko Matijas, Laura Skubal, Dean Walters, and Bob Wagner 28 September 2011
Timeline of events
• • • • • • • • • • • 28 April 2011 first discussion of water purifier 26 May 2011 specification of purifier settled on.
Discussion of Millipore versus Crossbow purifiers 28 June 2011 Millipore quotation distributed.
7 July 2011 demonstration by Millipore of DI purifier 19 July 2011 requisition entered into the purchasing system 22 August 2011 Millipore enters order into their system.
8 September 2011 Millipore system arrives 15 September 2011 wall brackets mounted on wall 22-23 September 2011 check out parts fit-up 27 September 2011 Millipore installs unit & trains staff
Planning
• • The DI Water Purifier has been planned for the south west corner of the Wet Lab (C-248).
This location facilitates DI water consumption in both the Wet Lab and the Photocathode Lab
Quotation
• • The Millipore Integral 10 system was sized to have the capacity and the flow for the anticipated needs of the Wet Lab.
The Integral 10 comes with (2) type 1 water dispensers, ultra pure, and (1) type 2 water dispenser, pure water.
– It was noted that SSL uses type 1 water to clean their parts.
– The APS clean line uses type 2 water to clean parts for vacuum usage.
Installation Preparations
Blank Canvas Bracket Locations
Ready for Installation
Installation by Millipore
John Halloran Millipore Corp.
Complete
Future Tasks
• • Dispenser in Photocathode Lab – Cut hole into wall between Wet and Photocathode Labs.
– Need either table or shelf for the MilliQ (type 1) dispenser.
Fume hood dispenser – Need table or shelf for the MilliQ dispenser – Install feed tube for filling the Citranox or rinse tanks.