Transcript Slic3r Print Settings Configuration

Layers and perimeters
Solid Layers Top=3
Perimeters
Layer Height
First Layer Height=.35 & Solid Layers Bottom=3
Infill Layer
If Solid Layer Top=3 the top
Three layers will be printed solid
Based on the Infill:Top/Bottom Fill
Pattern. In the image on the right
The top/bottom pattern is
Hilbertcurve. The Infill Layer is an
inner fill (non – solid) Honeycomb
layer.
Perimeter = 2
Infill:Fill
Pattern=Honeycomb
Perimeter = 6
Top layer fill patterns
Infill
Fill Density = 0.1
Fill Density = 0.4
Infill:Fill
Pattern=Rectlinear
Infill:Fill
Pattern=Honeycomb
Solid every
20th layer
Layers
Solid Layers
Bottom=7
Fill Angle=0
Fill Angle=45
Top/bottom fill patterns
concentric
Top/bottom fill patterns
Hilbertcurve
Top/bottom fill patterns
Rectlinear
Top/bottom fill patterns
Archimediancords
Top/bottom fill patterns
Octagramspiral
Skirt and Brim
Skirt Height = 5
Brim = 2.5mm
Loops = 3
Distance 6mm
Support Material
Object
Skirt
Raft
Layer 2 –applied parameters
Layer 1 – default fill
Layer 2 applies the Pattern, rectlinear,
at the pattern spacing and
angle. This pattern will be
repeated for the layer
specified in by Raft Layers
2.5mm
10mm
Pattern spacing=4mm
Five Interface layers
10 Raft Layers
{
{
Pattern spacing
change from 4
to 2.5
Object first
solid layer