Transcript Power Point - Idaho Irrigation Equipment Association

Presented by the Idaho Irrigation Equipment Association
To control snow and water run-off and manage water resources in Idaho, many
dams, canals, and ditches have been built. These man-made structures have
enabled the water to be diverted to water crops, parks, and landscaping.
Lucky Peak Dam in Western Idaho diverts water to the canals.
Irrigation is the controlled application of water for
agricultural and landscape purposes through
manmade systems. Because of Idaho’s climate,
farmers can’t count on regular rainfall to water
plants. So they use irrigation to water their plants
which results in producing some of the best
landscapes, crops and seed in the world.
5
2
1
4
3
The 2008 Farm and Ranch Irrigation Survey reported that United States farmers and ranchers
irrigated 54.9 million acres of farmland that year. In 2007, Idaho had almost 3.3 million acres of
irrigated land. The states with the largest area of irrigated lands are: 1) Nebraska 2) California
3) Texas 4) Arkansas and 5) Idaho.
This slide show will discuss six kinds of irrigation: landscaping- including home,
parks and commercial- flood, siphon tube, wheel line, drip line and center pivot.
Landscape
Irrigation
Sprinklers are a vital part
of landscaping for
homes, parks, golf
courses and businesses.
Instead of growing food,
desired crops are
flowers, trees, and
grass. A good sprinkler
system helps conserve
water and produces
beautiful landscapes and
scenery.
Flood Irrigation
Flood irrigation is water that
is pumped or brought to the
fields and is allowed to flow
along the ground among
the crops or fields. This
method is simple and
cheap, and is widely used
by societies in less
developed parts of the
world as well as in the
United States. Farmers can
capture the runoff in ponds
and pump it back up to the
front of the field where it is
reused for the next cycle of
irrigation.
Siphon
Tubes
Siphon tubes are a basic implement used in irrigation to transfer water over a barrier (such as the
bank of a raised irrigation canal), using the siphon principle. At the simplest, they consist of a
pipe with no working parts. To work they rely on the water level in the canal being at a higher
level than the water level in the field being irrigated. Like any siphon they must be primed (that is,
filled with water) before they will start reliably transferring water. Once primed and positioned
correctly, they will continue transferring water from the source to the destination.
Wheel Lines
Wheel Lines come in 40-foot sections and can be assembled into whatever length a farmer needs to cover.
They are normally propelled by a motor/mover in the middle of the line that rolls the wheel line across the
field, usually 50 feet to 60 feet per move. Crops are limited because of the short height of the pipe.
Drip
Irrigation
For irrigating fruits and vegetables this method is much more efficient than flood irrigation. Water is sent
through plastic tubes (with holes in them) that are either laid along the rows of crops or even buried along
their rootlines. Evaporation is cut way down, and 40 percent of the water used is saved, as compared to
flood irrigation. The above photo shows a field being irrigated by drip irrigation. The right side of the
picture is after 24 hours and the left side is after 12 hours.
Center
Pivots
The center-pivot systems have a number of metal frames (on rolling wheels) that hold the water tube
out into the fields. There can be a very big water gun at the end of the tube. Electric motors move each
frame in a big circle around the field (the tube is fixed at the water source at the center of the circle),
squirting water.