Transcript 2009 DPW Product & Accessories Sales Guide

Quietside DPW Unit
Product and Accessories
Heating Season Jan 2009
QUI-DPWBP-002
Who is Quietside?
• With two locations, on
opposite coasts
• West Coast location is in
Santa Fe Springs CA
• East Coast location is in
Carlisle PA
• Third location in the
Dallas/Fort Worth area
opening 2008
• Quietside distributes
these products, plus
Samsung Mini Splits,
Quietside Mini Splits from
these locations
Who is Quietside?
• Both locations provide
Customer service and
shipping but most
importantly :
• Full Technical Support
and Training is
available in both
locations
• Both locations have
bespoke classrooms
and hands on training
laboratories
What is a Dual Purpose Water
Heater
• A Dual Purpose Water Heater is a unit that will provide
both heating water for space heating and also potable
domestic hot water for washing from a single unit
without any additional controls required
• Domestic hot water is given priority over the space
heating, and is activated by flow through the domestic
hot water system
• DHW is “on demand” and continuous, it will be
provided as long as the faucet is open
• Once DHW call is completed the unit will revert to
heating the house as required
What is a Dual Purpose Water
Heater
• It is not called a Boiler in North America unlike the rest
of the world, this is because
• It does not provide closed loop heating water at a
temperature above 176 DegF
• It does not have an ASME H stamp, therefore cannot
be used in areas where this is a requirement
• Internal Water Volume is less than 1 gallon
• Therefore these units are certified by ANSI Z21.10.32004/CSA 4.3-2004 as a gas water heater
Who makes this unit?
DAESUNG CELTIC is a
Korean Gas boiler
manufacturer
established in 1982 Joint
investment agreement
with Chaffoteaux et Maury
Annually they produce and
supply over 150,000 gas
boiler products to Korea
and world wide market.
Currently selling product to
North America,
China, Russia, and several
CIS countries
The Manufacturer
• Annual Volume
150,000 units
• ISO 9001, ISO 14001,
Six Sigma certified for
quality
• Cell Manufacturing as
pioneered by Toyota
• All units are fully
tested before
packaging and
shipping
DPW NG/LP Wall Mount DPWH
• 2 Models
• DPW-099A
99,000 Btu/h Max Input
• DPW-120A
120,000 Btu/h Max Input
• All units are 90% AFUE
and Energy Star certified
• All units qualify at a 0.83+
EF for the IRS $300
rebate in the US
DPW Model Features
• All units are fully modulating
in capacity
• DPW-099
Range 47,800 – 99,000 Btu/h
• DPW-120
• Range 47,800 – 120,000
Btu/h
• Closed loop heating water
temperature range 122-176
DegF
• DHW temperature setting 98114 DegF, 120, 130 and 140
DegF
DPW Model Features
• Wet recuperative HX
manufactured from
Aluminum Alloy
• Removes latent heat
from the flue gas to
increase efficiency
• By product is
condensate, which is
drained away from the
unit via the condensate
siphon
• Condensate is slightly
acidic – PH level 5
DPW Model Features
• Exhaust and Inlet vent
connections for 3”
diameter Schedule 40
PVC
• Flue gas temperature,
max 136 DegF
• Max flue length 45ft
equivalent, max 3
elbows
• Vent termination
included
DPW Model Features
• Components included
include
• Primary loop circulator
provides flow for either
the Primary loop or
close coupled AHU
• Closed loop expansion
tank – similar in size to
a 20 gallon normal
expansion tank
DPW Model Features
• Flow switch on DHW cold
inlet connection detects
flow in the DHW system >
0.7 GPM
• 3 Way valve energizes to
direct heating loop flow
through DHW HX
• Unit fires to provide DHW
at temperature selected
until call is completed
• Temperature sensor on
DHW outlet measures
water temperature – unit
will modulate to maintain
temperature
DPW Model Features
• Microprocessor control
provides accurate
control of heating
water temperature and
all other operational
and safety features of
the unit
• Dip switches can be
used to set up unit for
various option
• 3Amp fuses protect
unit
DPW Model Features
• Unit controller included
• Sets heating loop
water temperature
from 122 – 176DegF
• Sets DHW
temperature 98 – 114
DegF, 120, 130 or 140
DegF
• Displays room
temperature but is not
a thermostat
• Shows error codes and
unit operation status
DPW Model Features
• Simple Zone wiring
• Two wires are used to
connect to an X – X or
dry contact (zero
voltage) on zone
controller or switching
relay
• Once contact is closed
unit will fire and
provide heating loop
water at temperature
selected on controller
Zone wires
DPW Model Features
• Self Diagnostic
• 13 Specific error codes
are displayed in the
event of a fault
occurring
• Range from
condensate overflow to
overheat to low water
level
DPW Model Features
• Built in closed loop
strainer, located on
return connection to
the unit
• Built in Air eliminator
for the closed loop
system – HOWEVER
always install an
additional high quality
air vent – Spirotherm
at highest point in the
system
DPW Model Features
• Modulating gas Valve
This allows turn down
of capacity over 50%
dependant on load in
the systems
• Spark ignition and
rectification flame
detection saves energy
and provides safety
should the unit not
ignite
DPW Accessories
• DHW Tank – Storage
tank to provide additional
DHW performance for
high DHW water demand
applications
• Buffer tank – Prevents
short cycling of the
heating system
• LP Conversion kits to
allow the unit to be field
converted to LP gas
supply
DPW + DHW Storage Tank
• Specifically designed for
use with DPW
• Available in a 20 Gallon
Size
• Combines the continuous
use of an On Demand
DHW supply with the flow
rate and instant hot water
of a tank, allows for use
of Jacuzzi tubs etc
• Design allows tank to be
completely depleted for a
tub, but still provides hot
water if a shower is taken
immediately after
DHW Storage Tank
• Supplied with for field
installation
• Taco 008 Pump
Assembly with
internal flow check
• Mixing Valve
• Pressure Relief Valve
• Tank Drain
• Aquastat to control
tank temperature
DPW & TC-001
• Conversion kit for
gas/electric tank
water heaters
• All component parts
needed to turn them
into a QSDHS system
including
• Mixing Valve
• Bronze pump with
integral flow check
DPW & Buffer Tank
• 20 Gallon Buffer Tank
• Used to prevent short
cycling of the unit during
mild temperature
operation or if smaller
zones than 20,000 Btu/h
heat loss are used
• Complete with all ports
required and an aqua stat
to provide a control input
for the DPW, and
maintain the set tank
temp
DPW & LP
• LP Kit for field conversion
• Unit specific, changes Nozzle assembly
• Will require use of a manometer to adjust gas pressures
to correct settings
DPW Warranty
• Standard Warranty
• Heat Exchangers
12 Years
• All other Parts
5 Years
Literature Available
DPW
• Sales Brochure
• Submittal
• Basic Application Guide including a
detailed Troubleshooting Guide
• Piping and Wiring Diagrams for various
applications
• DPW IOM
• Website : www.quietside.com
Support Available
Sales Support
Local Representation
Technical Support
East Coast
717 243 2535
Quietside sales staff
Regionalized
Customer Support
West Coast
562 699 6066
Website :
www.quietside.com