Transcript Practical Signal Reconstruction (Interpolation)

CHAPTER 6
SAMPLING AND ANALOG-TO-DIGITAL
CONVERSION
Fundamental of Wireless Communications
ELCT 332
Fall 2011
1
Sampling Theorem
Nyquist Rate
Nyquist Interval
Fundamental of Wireless Communications
ELCT 332
Fall 2011
2
Signal Reconstruction from Uniform Samples
Interpolation: The process of reconstructing a continuous time signal g(t) from its
samples
Fundamental of Wireless Communications
ELCT 332
Fall 2011
3
Practical Signal Reconstruction (Interpolation)
Fundamental of Wireless Communications
ELCT 332
Fall 2011
4
Simple interpolation
Fundamental of Wireless Communications
ELCT 332
Fall 2011
5
Practical Issues in Signal Sampling and Reconstruction
Realizability of Reconstruction Filters
Fundamental of Wireless Communications
ELCT 332
Fall 2011
6
Practical Issues in Signal Sampling and Reconstruction
The Treachery of Aliasing
Aliasing effect. (a) Spectrum of a practical signal g(t). (b) Spectrum of sampled g(t).
(c) Reconstructed signal spectrum. (d) Sampling scheme using antialiasing filter.
(e) Sample signal spectrum (dotted) and the reconstructed signal spectrum (solid) when antialiasing filter is used.
Fundamental of Wireless Communications
ELCT 332
Fall 2011
7
Maximum Informaiton Rate
A maximum of 2B independent pieces of information per second can be transmitted,
error free, over a noiseless channel of bandwidth B Hz
(a) Non-band limited signal spectrum and its sampled spectrum G( f ).
(b) Equivalent low-pass signal spectrum Ga( f ) constructed from uniform samples of g(t) at sampling rate 2B.
Fundamental of Wireless Communications
ELCT 332
Fall 2011
8
Nonideal Practical Sampling Analysis
Fundamental of Wireless Communications
ELCT 332
Fall 2011
9
Applications of Sampling Theorem
Pulse Amplitude Modulation (PAM)
Pulse Width Modulation (PWM)
Pulse Position Modulation (PPM)
Fundamental of Wireless Communications
ELCT 332
Fall 2011
10
Applications of Sampling Theorem
Time Division Multiplexing (TDM)
Fundamental of Wireless Communications
ELCT 332
Fall 2011
11
Pulse Code Modulation (PCM)
Natural binary code (NBC)
Binary digit (bit)
For a audio signal with a bandwidth about 15kHz, the signal is not affected if all the
above 3400 Hz are suppressed. If sampled at a rate of 8000 samples per second, and
each sample is finalized quantized into 256 levels, the telephone signal requires how
many binary pulses per second?
Fundamental of Wireless Communications
ELCT 332
Fall 2011
12
Quantizing
Fundamental of Wireless Communications
ELCT 332
Fall 2011
13
Nonuniform Quantizing
uLaw
ALaw
Fundamental of Wireless Communications
ELCT 332
Fall 2011
14
The Compandor
The Compressor and expander together are called the compandor
Fundamental of Wireless Communications
ELCT 332
Fall 2011
15
Examples: Transmission Bandwidth and the Output SNR
A signal m(t) band-limited to 3kHz is sampled at a rate 33.333% higher than the Nyquist rate.
The maximum acceptable error in the sample amplitude (the maximum quantization error) is
0.5% of the peak amplitude mp. The quantized samples are binary coded. Find the minimum
bandwidth of a channel required to transmit the encoded binary signal. If 24 such signals are
time-division-multiplexed, determine the minimum transmission bandwidth required to transmit
the multiplexed signal.
Nyquist rate RN=6000Hz
Sampling rate RA=8000Hz
L=200
N=8, CM=24*64000/2=0.768MHz
Fundamental of Wireless Communications
ELCT 332
Fall 2011
16
Exponential Increase of the Output SNR
A signal m(t) of bandwidth B=4kHz is transmitted using a binary companded PCM with μ=100.
Compare the case of L=64 with the case L=256 from the point of view of transmission
bandwidth and the output SNR.
Fundamental of Wireless Communications
ELCT 332
Fall 2011
17
Digital Telephony
T1 carrier system.
Fundamental of Wireless Communications
ELCT 332
Fall 2011
18
Digital Telephony
T1 system signaling format.
Fundamental of Wireless Communications
ELCT 332
Fall 2011
19
Differential Pulse Code Modulation (DPCM)
By estimating the value of the kth sample m[k] from a knowledge of several previous
sample values. We transmit the difference between m[k] and its predicted value.
More band efficient, and better SNR
Line Predictor
Transversal filter (tapped delay line) used as a linear predictor.
Fundamental of Wireless Communications
ELCT 332
Fall 2011
20
Differential Pulse Code Modulation (DPCM)
SNR Improvement: mp, dp
DPCM system: (a) transmitter; (b) receiver.
Fundamental of Wireless Communications
ELCT 332
Fall 2011
21
Adapative Differential Pulse Code Modulation (ADPCM)
ADPCM encoder uses an adaptive quantizer controlled only by the encoder output bits.
Fundamental of Wireless Communications
ELCT 332
Fall 2011
22
Vocoders And Video Compression
Linear Prediction Coding
(LPC)
(a) The human speech production mechanism (b) Typical pressure impulses.
Fundamental of Wireless Communications
ELCT 332
Fall 2011
23
LPC Models
Analysis and synthesis of voice signals in an LPC encoder and decoder.
Video Compression: MPEG
NTSC TV in digital form 45-120 Mbit/s------- 1.5-15Mbit/s
HDTV in digital form 800 Mbit/s------- 19.39Mbit/s
Fundamental of Wireless Communications
ELCT 332
Fall 2011
24