Day Tank and Pump Selection

Download Report

Transcript Day Tank and Pump Selection

Pumping Systems
and
Day Tanks
Presented
By
Ken Still, CB Kramer
1
Agenda
•
•
•
•
•
•
•
•
•
2
Introduction
Basic System
Generator Pump Selection
Boiler Pump Selection
Pump Types and Limits
Day Tanks
Day Tank Accessories
Pump and Day Tank Control
Conclusion
Introduction
• Ken Still – CB Kramer
• Pump sets and day tanks typically operate as a
single system with a common controller.
3
Basic System
Monitoring
and Control
4
Generator Pump Selection
• 7 gph per 100KW = GPH
• GPH x # gensets = GPH Total
• GPH total x 4 = transfer
pump size
5
6
Boiler Pump Selection
Typical boiler system selection
• 30gph per 100 BHP = GPH
• GPH x # boilers = GPH total
• GPH total x 2.5 – 3 to
accommodate boiler mounted
pump total flow
7
8
Typical System w Boiler Pumps
• Boiler Mounted pump limitations
• Tight pump suction limits; 15”hg – 3psi
• Boiler pump single point of failure
• Boiler pumps requires 2.5-3 times flow rate
(sometimes 10-15x more) from transfer pump
9
Typical System w Boiler Pumps
10
Alternative Boiler System
80 - 90
11
Pump Types
SUCTION PUMP SET
PRESSURE (submersible) PUMPS
• Match the pump to the application
• Suction or pressure type
12
Pump Sets
• Submersible Pumps
• Pro
• Submerged suction
• Simple single tank
systems
• Simple installation
13
• Con
•
•
•
•
•
•
Pressurized in-ground piping
Limited sizes
Difficult maintenance
Unmanned spaces
Piping Monitoring
Complicated multi-tank
redundant systems
Pressure Pump System
• Redundancy
• Each tank must have
redundant pumps
14
Pump Sets
• Suction Pumps
• Pro
• Buried piping under
suction
• Ease of maintenance
• Simpler multi tank
systems
• Simple installation
15
• Con
• Limited suction ability
• Additional floor space
Suction Pump System
• Redundancy
• A single duplex pump
set satisfies
redundancy
requirement
16
Suction Pump Set Options
• High Pressure 100psi
• Low Pressure <50 psi
mechanical
pump set
17
pump set with
motor starter panel
Pump set with motor starter
and logic control panels
Suction Pump Set Contruction
Control panel(s)
Relief valves
Flow switch
Priming funnel
Suction strainer(s)
Gauges
Pump/motor sets
Reservoir base w/leak switch
18
Basic System
Monitoring
and Control
Day Tanks
19
Day Tanks
• Built and certified to UL142
• Pressure tested to 5 psi
• Almost always used on generators
• Stand Alone
• Belly Tank
• Sometimes used on boilers
20
Day Tanks
• Stand Alone
• Generator Belly Tank
21
Belly Tanks
• Completely isolate tank
from generator
Flexible fuel hose
Spring isolation
22
Independent Day Tanks
• Double Wall
• Return Pump Option
23
Independent Day Tanks
• Single Wall
• Single Wall w/Tub Type Rupture Basin
• Available w/o rupture basin
24
Day Tank Accessories
• Automatic fill manifold
• Multi-tank applications
• Sized to precisely match required flow
25
Day Tank Accessories
• Return Pumps
• Manipulate tank level
to test controls
• Refresh fuel if it
overheats
• Empty day tank in
emergency
26
Day Tank Accessories
• Accessories
•
•
•
•
27
Vent Caps
Level Indication
Level Monitoring
Others
Day Tank Sizing
• No rules or regulations requiring minimum
sizes.
• Some regulations limiting maximum sizes
• IFC limit to 660 gallons in certain installations
• Generator KW x .07 x hours desired = tank size
• Often space dependent
28
Day Tank Construction
•
•
•
•
29
Fittings in top of tank (except drain)
Easy access to all fittings
Drop tubes on all supply and returns
Keep the inflow away from generator suction
Pump and Day Tank Controls
• Primary functions
• Monitor day tank level
• Start/stop pumps
• Open/close fill manifolds
• Secondary functions
• Leak detection
• Communications and alarms
• Auxiliary controls
30
Pump and Day Tank Controls
• Safe Design
• High voltage separate
from low voltage
• Easy serviceability and
compliance to NFPA
and OSHAE standards
31
Low voltage logic control
not to exceed 49 volts
High voltage motor
control panel
Pump and Day Tank Controls
• NFPA 70e
32
Conclusion
•
•
•
•
•
•
•
33
Basic System
Generator Pump Selection
Boiler Pump Selection
Pump Types and Limits
Day Tanks
Day Tank Accessories
Pump and Day Tank Control