Transcript Airmux 200 Marketing Presentation

AirMux-200
Product Launch
AirMux-200 Highlights
• Up to 48 Mbps air interface throughput*
• Net payload is 18 Mbps, full-duplex
• Combination of E1 or T1 and Ethernet
• Range up to 80 km/50 miles*
• Carrier-class performance
• RADview SNMP network fault management
• Easy to install
* Rate is adaptive to range
AirMux-200 Product Launch Slide 2
Roll Out
Released
• 5.725 - 5850 GHz
• Up to 2 x E1 or 2 x T1, and Ethernet
December 2004 Pre-Release Version
• 5.250-5.350 GHz
• 2.400-2.4835 GHz ETSI and FCC regulation
• 4 x E1 or 4 x T1 ports, and 2 x Ethernet ports
• Carrier-class indoor unit (IDU)
• Power over Ethernet IDU
February 2005 Pre-Release Version
• 5.470-5.725 GHz complying with ETSI and FCC
• Supports Transmit Power Control (TPC) and Dynamic
Frequency Selection (DFS)
• Encryption: according to AES 128
AirMux-200 Product Launch Slide 3
Typical Application
Remote Site
Server
HQ
Up to 80 km/50 miles
Switch
Switch
LAN
LAN
V24
n x FXS
Packet
PBX
Megaplex
n x E1
AirMux-200
AirMux-200
n x E1
V.35
PSTN
Router
Main Drivers
• Fast ROI versus leased lines
• Fast deployment and equipment reuse
• Broadband infrastructure enabler
• Backup for terrestrial lines
AirMux-200 Product Launch Slide 4
AirMux-200 System Components
Outdoor Units (ODU)
• ODU with integrated antenna,
includes pole and wall mount
brackets
• ODU for connecting an external
antenna, includes “N” type
connector
• Standard outdoor
Cat.5e cable for connecting ODU
to IDU
AirMux-200 Product Launch Slide 5
Indoor Unit (IDU) Configurations
IDU
•
•
•
– Standard indoor unit
Ethernet
Ethernet + E1 or T1
Ethernet + 2 x E1 or 2 x T1
IDUE – Carrier-class indoor unit
• 2 x Ethernet + 4 x E1 or 4 x T1
IDUD – Power over Ethernet unit
• Ethernet
AirMux-200 Product Launch Slide 6
Air Interface Features
Frequency Bands
5.725-5.850 GHz ^
5.470-5.725 GHz *
5.250-5.350 GHz ^
2.400-2.4835 GHz *^
Channel Bandwidth
20 MHz
RF Channel Selection
Via NMS, 5 MHz Resolution
Standard
FCC, *ETSI, ^CAN/CSA
Polarization
Linear (V or H)
Antenna Gain (dBi)
Integrated
External
22 (5.x GHz)
28 (5.x GHz)
17 (2.4 GHz)
24 (2.4 GHz)
Antenna Beamwidth
9.0 degrees
4.5 degrees
Sensitivity (dBm)
-84
-81
-74
-68
Rate (Mbps)
12
18
36
48
Modulation
BPSK
QPSK
16QAM
64QAM
@ BER < 10e-11
AirMux-200 Product Launch Slide 7
Typical Throughput
Air Interface
Rate
Throughput
Throughput left for Ethernet
Maximum
full-duplex
traffic when using TDM Service
Range
(Mbps)
(Mbps)
1 x E1
2 x E1
1 x T1
2 x T1
(km)
(miles)
12
4.2
2.0
N/A
2.5
0.88
41
25.5
18
6.5
4.4
2.3
4.8
3.2
25
15.5
36
13.6
11.5
9.3
11.9
10.2
10
6.0
48
18.3
16.2
14.0
16.6
14.9
4
2.5
* Figures are for 22 dBi integrated antenna, at 5.725-5.850 GHz band.
Maximum range is 80 km/50 miles with 28 dBi antenna at same band.
AirMux-200 Product Launch Slide 8
Carrier-Class Performance
• Jitter and wander according to G.823.4
• Clock recovery (<0.05 PPM)
• E1 delay is 8 msec
• TDM circuit BER < 10e-11 @ sensitivity threshold
• Ethernet delay less then 3 msec
• Lossless Ethernet traffic
AirMux-200 Product Launch Slide 9
Management
Airmux Manager:
• SNMP-based
• Installation wizard
• Link-based configuration for management of link with
single IP address
• On-line monitoring of air interface, E1/T1 and Ethernet
services
• Maintenance
• E1/T1 Local and Remote loopbacks
• Over-the-air software upgrade
RADview SNMP Network Fault Management
AirMux-200 Product Launch Slide 10
Easy Installation and Alignment
• No need for digital volt meter (DVM)
• Survey performed by ODU
• Audio indication for optimal
received signal strength (RSS)
• Per-link configuration and settings
• Unique system signal identification
• No pre-installation setting is required
• Light-weight ODU
AirMux-200 Product Launch Slide 11
License-Free Coverage
Frequency
License-free Coverage Region
5.725-5.850 GHz FCC,
USA, Canada, Mexico, Brazil, Argentina, China,
CAN/CSA
Australia, New Zealand, Taiwan, Hong Kong, UK*, Spain
5.470-5.725 GHz FCC
USA
5.470-5.725 GHz ETSI
5.250-5.350 GHz FCC,
CAN/CSA
2.400-2.483.5 GHz FCC,
CAN/CSA
2.400-2.483.5 GHz ETSI
Germany, Italy*, Belgium, Denmark, Sweden, Finland,
Ireland
USA, Canada
USA, Canada, Taiwan
Most EU countries, Israel
* Special limitations or requirements may apply here
• Regulated coverage in many other regions
AirMux-200 Product Launch Slide 12
AirMux-200 Applications
• AirMux-200 provides a high return on
investment in a variety of campus, enterprise
and service provider applications. These include:
• Lossless Hot Spot Backhauling
• Telephone Service Extension to Remote/Rural Locations
• Multiple Services in Daisy Chain Topology
• Multiple Services with Unique E1/T1 Ring Protection
• Emergency Services and Temporary Deployment
• Wireless Backup
• Interconnecting Multiple Legacy Services over Packet Networks
• Cellular Backhaul
• Cellular Backhaul with TDMoIP Mesh Protection
• Voice Traffic Extension over Wireless
AirMux-200 Product Launch Slide 13
Lossless Hot Spot Backhauling
Hot Spot
Ethernet
Access Point
ISP
5.x or 2.4 GHz
AirMux-200
Ethernet
AirMux-200
Packet
Router
• Supports full 5.x GHz and 2.4 GHz bands for
lossless hot spot backhauling including band
and channel separation
• Transparent Ethernet forwarding
• Ethernet and power over Ethernet ODU/IDU
connection
AirMux-200 Product Launch Slide 14
Telephone Service Extension to
Remote/Rural Locations
Remote/Rural Location
MP-104/204
5.x or 2.4 GHz
E1
E1 MP-2104/2100
AirMux-200
CPE
PSTN
AirMux-200
E1
Remote/Rural Location
MP-104/204
5.x or 2.4 GHz
E1
AirMux-200
Central Site
AirMux-200
CPE
• Extends telephony services to remote or rural
areas
• Megaplex units serve as channel banks at the
remote end, and as aggregation devices at the
center
AirMux-200 Product Launch Slide 15
Multiple Services in Daisy Chain
Topology
AirMux-200
V.52
MP-2104
AirMux-200
AirMux-200
MP-2104
AirMux-200
FCD-IP
FCD-IP
• Drop-and-insert topology saves cost of lease lines or
infrastructure investment
• Drop of any service
• Optimized solution for specific node requirements
• Target markets: utilities, cellular, transportation
AirMux-200 Product Launch Slide 16
Multiple Services with Unique E1/T1
Ring Protection
Fire Alarm
FCD-IP
4 x E1/T1
Ring
Typical users:
MP-2100
• Campus
• Cellular
• Utilities
NMS
Servers
PBX
MP-2104
• Unique ring protection
• Optimized solution for
specific node
requirements
• Any service
AirMux-200 Product Launch Slide 17
Emergency Services and
Temporary Deployment
Central Site
AirMux-200
Remote Site
n x links
Switch
Switch
Megaplex
n x E1
AirMux-200
AirMux-200
DXC
• Enables mobility and fast deployment
• Typical users: military, emergency services, broadcast, etc.
AirMux-200 Product Launch Slide 18
Wireless Backup
Site A
CPE
G.703
AirMux
AirMux
DXC
Site B
DXC
F.O or Copper
CPE
G.703
RADview
NMS
• Automatic switch-over with DXC
• Typical users: financial organizations, government,
military
AirMux-200 Product Launch Slide 19
Interconnecting Multiple Legacy
Services over Packet Networks
Router
AirMux-200
V.35
IPmux-14
AirMux-200
Ethernet
LAN
IPmux-8/16
4-16
E1/T1
Ethernet
Ethernet
Services
PBX
n x E1/T1
Ethernet over Fiber
Cable PLC
NMS
IPmux-14
Ethernet
LAN
• End-to-end transmission of multiple user services over IP, with
central demarcation and aggregation IPmux units
• Adds Ethernet traffic engineering tools such as rate limiting and
VLAN stacking
• End-to-end service provisioning with RADview-SC/TDMoIP
AirMux-200 Product Launch Slide 20
Cellular Backhaul
BTS Site
BTS
AirMux-200
n x E1
BSC Site
Switch
10/100BT
Packet
AirMux-200
BSC
n x links
TDM
BTS Site
E3
BTS
n x E1
AirMux-200
Ethernet
DACS
AirMux-200
• Integration of cellular, monitoring
and management traffic
• 0.05 ppm clock
recovery
• Future migration to IP 3G BTS
• 8 msec E1 or T1
delay
• Cost-effective alternative to
Microwaves
• High link availability
• 3 msec Ethernet
delay
AirMux-200 Product Launch Slide 21
Cellular Backhaul with TDMoIP®
Mesh Protection
BTS Site
BTS
BSC Site
1-4 x E1
AirMux-200
IPmux-14
BSC
2 x 10/100BT AirMux-200
BTS Site
Up to 16 x E1
Backbone
n x links
IPmux-16
BTS
n x F.Eth
1-4 x E1
AirMux-200
IPmux-14
2 x 10/100BT AirMux-200
• Complies to clock accuracy, jitter and wander
GSM requirements
• Protection via packet ring or mesh topology
• 25%-50% equipment savings versus 1+1 protection
AirMux-200 Product Launch Slide 22
Voice Traffic Extension
over Wireless
Branch #1
PBX
Up to 80 km/50 miles
Vmux-110 E1/T1
AirMux-200
Headquarters
Vmux-2100
AirMux-200
Router
Branch #2
E1/T1
PBX
IP / TDM
Network
PBX
IP or
E1/T1
Vmux-110 E1/T1
E1/T1
PSTN
• High link utilization with up to 16:1 compression ratio
• Enables extending E1 or T1 over IP for up to
80 km/50 miles
AirMux-200 Product Launch Slide 23
Summary of AirMux-200 Benefits
• Best price/performance in the industry - Fast ROI
• Combination of up to 4 x E1/T1 plus Ethernet, with
high traffic throughput
• High link availability with carrier-class performance
• Reduction of deployment time and expenses as part of a
complete interoperable solution with other RAD devices
(e.g. Megaplex Multiservice Access Multiplexers)
• Management of hundreds of links and access devices from a
single SNMP fault management application
• Enhanced security with standard encryption mechanism
• Easy deployment via installation and alignment tools
AirMux-200 Product Launch Slide 24
Thank You
for your attention
Tel: 1-888-785-7393
Int’l: 1-951-694-1173
Email: [email protected]
www.airmux.com
AirMux-200 Product Launch Slide 25